Model reference

Amana SD22W-P60340-52W

Refrigerator

2 documents32 error codes5 service modes

Available documentation

Service Manual

Built-in Coffee System76 pg
Covers this model

Tech Sheet

Tech Sheet - W10531678 - Rev A (FR)_W1053167816 pg
Covers this model

MyPros+ Max

Diagnose your Amana SD22W-P60340-52W.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Amana Refrigerator

1-1 on my Amana SD22W-P60340-52W

M+

Control module detected relay K1 stuck

From Tech Sheet W17466209, p.21:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (32)

CodeMeaning

1-1Control module detected relay K1 stuck in closed position.1-2Control module software problem 10-1Dispenser electrical problem 2-1User interface 3-1Temperature sensor/soil sensor 3-2Temperature sensor/soil sensor 3-3Soil sensor (OWI) calibration impossible 4-3Wash motor non-operation 5-1Door switch 5-2Door switch stuck in closed position 6-1Water inlet 6-2Fill valve electrical problem 6-3Excessive sudsing/air in pump.6-4Overfill float switch open 6-6Water too cold 7-1Heating 7-2Heating element constantly energized 8-1Slow drain 8-2Drain motor electrical problem 8-3Drain circuit constantly energized 9-1Diverter valve problem 9-2Diverter valve problem.ADD GROUND COFFEEThe ground coffee function has been selected without placing any ground coffee…CLOSE DOOR!The service door is open.DESCALE!The flowmeter has measured that the volume of water used exceeds the set limit…FILL BEANS CONTAINER!Coffee beans have run out, or clutch is obstructed by stones or foreign objects…FILL TANK!Water tank is empty, incorrectly positioned, or the reed sensor/float is…GENERAL ALARMInternal fault detected during startup or operation, caused by NTC failure…GROUND TOO FINE ADJUST MILLWater is running off too slowly due to fine grind setting, removed water tank…INSERT BREWING UNITThe brewing unit has not been replaced after cleaning.

View all 32 error codes

INSERT GROUNDS CONTAINERAfter cleaning, the coffee grounds container has not been replaced.INSERT MILK CONTAINER!The milk container is missing or incorrectly positioned.

Service modes (5)

cycle_step_throughPress and hold the Cycle Select button for 5 seconds
diagnosticIn standby mode, press any 3 keys in sequence 1-2-3-1-2-3-1-2-3 with less than one second between…
Display Test Mode["With the coffee system in standby (plugged in with the main switch on but the machine off), open…
Load Test Mode["With the coffee system in standby (plugged in with the main switch on but the machine off), open…
Reset Upper Position of Infuser["With the machine in standby (plugged in with the main switch on, but machine off), open the…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana refrigerator models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass