Model reference
Amana SDI25F-1-P75400-15W
Refrigerator
1 document43 error codes4 service modes
Available documentation
Installation Guide
- Installation Instructions22 pg
MyPros+ Max
Diagnose your Amana SDI25F-1-P75400-15W.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (43)
CodeMeaning
F0Default F codeF0 E0No failure (default state).F1Electronic control malfunction.F1 E0Internal error (display board related).F1 E1Internal error (display board related).F1 E2Internal error (display board related).F1 E3Internal error (display board related).F1 E4Internal error (display board related).F1 E5Internal error (power board related).F1 E6Internal error (power board related).F1 E7Internal error (power board related).F1 E8Internal error (power board related).F1 E9Internal error (display board related).F1-E0Key held down too long or key is shorted.F1-E1Keypad keytail not connected.F1-E5CANCEL key drive line open.F1-E6CANCEL key drive line open.F2 E0Stuck key (shorted key) on keypad.F2 E1Keypad disconnect or keypad disconnected.F2-E0Temperature sensor opened (R=2875 ohm by spec).F2-E1Temperature sensor shorted (R=825 ohm by spec).F2-E2Oven temp too highF2-E3Oven temp too highF3 E0Main oven sensor open (top oven sensor opened).F3 E1Main oven sensor shorted (top oven sensor shorted).F3 E2Meat probe shorted.F3 E4Bottom oven sensor open (bottom oven sensor open).F3 E5Bottom oven sensor shorted (lower/bottom oven sensor shorted).F3 E6Warming drawer sensor open.F3 E7Warming drawer sensor shorted.View all 43 error codes
F3-E0Door is open but latch is locked (door switch open indicating open door, latch…F3-E1Self-clean latch will not lock/unlock.F4 E2Over temperature during cook mode (temperature runaway).F4 E3Over temperature during clean mode (temperature runaway).F4 E7Over temperature cavity 2 (temperature runaway error).F5Door latch or lock system fault (referenced with F3 latch troubleshooting…F5 E0Door latch mismatchF5 E1No operating latch or latch not operating.F5 E2Door switch fault.F5 E4Latch switch fault.F5 E7Unlock door errorF6 E4Lost communication between display board and power board.F6 E5Cancel key error.
Service modes (4)
- Bake Temperature Offset AdjustmentPress BAKE pad for 5 seconds
- Cavity Size ProgrammingWithin 60 seconds of power up, press the following touchpads in sequence
- Diagnostics mode["Press the Cancel key to place the range in an idle state (if error code is not…
- Fahrenheit to Celsius ConversionPress the BROIL pad for 5 seconds
Full entry steps, exit procedures, and test sequences are available in Max.
Related Amana refrigerator models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass