mypros+
Model reference

Amana SR19C-P73900-1W

Refrigerator

2 documents57 error codes11 service modes

Available documentation

Installation Guide

  • Installation Instructions84 pg
    Covers this model
  • Instrucciones de instalacion17 pg
    Covers this model
MyPros+ Max

Diagnose your Amana SR19C-P73900-1W.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (57)

CodeMeaning
:Flashing colon indicates a power failure has occurred.1-1Control detected K1 pilot relay stuck closed.1-2Control software issue10-1Dispenser electrical problem10-3Drying fan error2-1Control detected stuck key(s) in keypad or keypad connection.2-2No response from User Interface (UI)3-1Open connector or component in Temperature Sensing circuit; open or faulty…3-2Shorted temperature sensing circuit3-3Failed OWI calibration4-3Wash motor not running4-3 (cause 2)Control Motor Drive circuit or Sense circuit failure preventing wash motor…5-1Door stuck open5-2Door stuck closed6-1Low/no water (mechanical problem)6-2Fill valve electrical problem6-3Suds/air in pump6-4Float switch open6-6Incoming water under 84°F (29°C)6-7Disconnected or damaged flowmeter.6-8Regen valve electrical problem7-1No heat7-2Heater stuck on8-1Slow drain8-2Drain motor electrical problem8-3Drain motor stuck on9-1Diverter can't find position9-2Diverter stuck on9-3Diverter disc missingd1Upper dryer door sense problem on control board or due to power line…
View all 57 error codes
d12Lower dryer motor sensed problem.d13Blocked Coin 2 or coin drop circuit problem.d14Upper dryer motor sensed problem.d16Card reader communication problem (PR models only).d17Lower dryer door sense problem on control board or due to power line…d20Lower dryer motor control circuit problem.d4Upper dryer motor control circuit problem.d5Blocked Coin 1 or coin drop circuit problem.d9Voltage problemF0-0No error; initial factory setting.F1-1Over temperature while cooking.F1-3Over temperature while cleaning.F1-5Cancel key input out of range.F1-7Keyboard disconnected.F1-8Shorted key.F1-9Slave micro not functioning.F1-AVCC/GND lift off.F1-CControl not calibrated.F1-EEEPROM data corruption.F2Touch panel failure.F3-1Sensor or sensor circuit failure.F3HHumidity sensor failure.F6MW relay (Relay 4903) failureF9-1Auto latch will not lock.F9-2Auto latch will not unlock.NTC OPEN, CALL FOR SERVICEHood thermistor is open.NTC SHORT, CALL FOR SERVICEHood thermistor is shorted.

Service modes (11)

  • Child lock out["Press the 7 key and hold for 3 seconds."]
  • Customer Cycle Rapid AdvanceAfter starting a customer cycle, press HIGH TEMP
  • Diagnostic ModeDepress DELICATES for one second while in any of the set-up codes one through six (or while dAS…
  • Help ModePress the Whites & Colors keypad while in special pricing option step 2.XX (or while dAS displays…
  • Lower Dryer Field Diagnostic CycleFrom diagnostic mode (entire display flashing), press the LOWER DRYER PERMANENT PRESS keypad to…
  • Sabbath mode (BAKE mode only)["Press BAKE, enter desired temperature and press START.","Press the 8 key and hold for 3…
  • Self-diagnostic test mode["1
  • Service Diagnostics CycleWhile in Standby, press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1 second…
  • Service Diagnostics with Error CodesPress any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1 second between key presses.
  • Temperature adjustment (BAKE mode only)["Press BAKE pad.","Press in oven temperature of 500°F.","Immediately press and hold BAKE until…
  • Upper Dryer Field Diagnostic CycleFrom diagnostic mode (entire display flashing), press the UPPER DRYER PERMANENT PRESS keypad to…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana refrigerator models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass