Model reference

Amana TA-14D

Name: Amana TA-14D
Brand: Amana

Refrigerator

12 documents52 error codes29 service modes

Available documentation

Installation Guide

Installation Instructions11 pg
Covers this model
Installation Instructions18 pg
Covers this model
Installation Instructions17 pg
Covers this model
Installation Instructions19 pg
Covers this model
Installation Instructions7 pg
Covers this model
Installation Instructions18 pg
Covers this model
Installation Instructions16 pg
Covers this model
Installation Instructions18 pg
Covers this model
Installation Instructions17 pg
Covers this model
Installation Instructions6 pg
Covers this model
Instrucciones de instalacion19 pg
Covers this model
Installation Instructions11 pg
Covers this model

MyPros+ Max

Diagnose your Amana TA-14D.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Amana Refrigerator

1c1c on my Amana TA-14D

M+

Shorted key detected on control circuit

From Tech Sheet W14961655, p.27:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (52)

CodeMeaning

1c1cShorted key detected on control circuit board.1c2cKeyboard tail disconnected (improper loop value).1c31Cancel key circuit problem (improper value) for upper/single oven cavity.1c32Cancel key circuit problem (improper value) for lower oven cavity.1c4cPower micro communication failure (CRC invalid).1c6cEEPROM access error (no response from EEPROM after 3 tries).1c7cControl not calibrated (calibration value out of range).1c81Cook profile corrupted in EEPROM for upper/single oven cavity.1c82Cook profile corrupted in EEPROM for lower oven cavity.1d11Runaway temperature (650°F) with door unlocked; sensor resistance >2237 ohms…1d12Runaway temperature (650°F) with door unlocked; sensor resistance >2237 ohms…1d21Runaway temperature (950°F) with door locked; sensor resistance >2787 ohms for…1d22Runaway temperature (950°F) with door locked; sensor resistance >2787 ohms for…3d11Temperature sensor failure (open) for upper/single oven cavity; sensor…3d12Temperature sensor failure (open) for lower oven cavity; sensor resistance…3d21Temperature sensor failure (short) for upper/single oven cavity; sensor…3d22Temperature sensor failure (short) for lower oven cavity; sensor resistance <0…3d41Meat probe shorted; probe resistance <0 ohms.3d51Meat probe not calibrated (calibration value out of range).4d11Door switch position failure for upper/single oven; door switch not closed when…4d12Door switch position failure for lower oven; door switch not closed when door…4d21No Reverse Airflow Fan rotation (no/low RPM) for upper/single oven.4d22No Reverse Airflow Fan rotation (no/low RPM) for lower oven.4d31Reverse Airflow Fan state error (on when supposed to be off) for upper/single…4d32Reverse Airflow Fan state error (on when supposed to be off) for lower oven.4d41High Reverse Airflow Fan rotation (high RPM) for upper/single oven.4d42High Reverse Airflow Fan rotation (high RPM) for lower oven.4d51Door switch circuit failure (not open or closed) for upper/single oven.4d52Door switch circuit failure (not open or closed) for lower oven.9d11Latch will not lock; lock switch not closed for upper/single oven.

View all 52 error codes

9d12Latch will not lock; lock switch not closed for lower oven.9d21Latch will not unlock; unlock switch not closed for upper/single oven.9d22Latch will not unlock; unlock switch not closed for lower oven.9d31Latch both locked and unlocked (lock and unlock switches both closed) for…9d32Latch both locked and unlocked (lock and unlock switches both closed) for lower…F1 E1ACU (Appliance Control Unit) Fault.F1 E4UIC (User Interface Control) Fault.F1 E7Voltage Input Fault.F2 E1Dryer keypad is sensed pressed for 10 seconds (stuck key error); fault will…F5 E1Dryer Door Circuit Error.F6 E1Communication Failure Between ACU and UIC FC E1Model/Serial number not programmed on the control.FC E2Model/Serial number not matching between ACU and UIC.FC E3Wi-Fi Connection Fault.FC E4USB Fault FC E5Software Update Failure FC E6Model Setup Export Failure FC E7Model Setup Import Failure FC E8Wi-Fi Module not responding or not connected.FP E1Coin 1 Circuit Error.FP E2Coin 2 Circuit Error.FP E3Card Reader Communication error.

Service modes (29)

24-Hour Clock TogglePress and hold CANCEL and DELAY pads for 3 seconds
Child Lockout (Control Lock)Press and hold CANCEL and COOK & HOLD pads for 3 to 5 seconds until beep sounds.
Clock Display TogglePress and hold CANCEL and CLOCK pads for 3 to 5 seconds.
Diagnostic Code Display Mode["Power up the control.","Within 30 seconds of powering up, press and hold the MORE+ pad.","Cycle…
Diagnostic Code Display Mode (H1 Controls)Press and hold AUTOSET pad for 3 seconds at power-up.
Diagnostic Code Display Mode (H3 Controls)Press and hold Upper Cancel and Timer for 3 to 5 seconds within 5 minutes of power up.
Diagnostic Code Display Mode (NSC Controls)Press and hold the More + pad for 3 to 5 seconds when powering up the unit (within 60 seconds of…
Diagnostic Mode["Enter setup mode first.","Navigate to any of the set-up codes 1 through 6 (or while dAS displays…
Factory Default ResetPress and hold CANCEL and KEEP WARM pads for 3 to 5 seconds.
Faults Access (EOC III Controls)1
Help Mode["Enter setup mode first.","Navigate to special pricing option step 2.XX (or while dAS displays if…
Model/Serial Number Menu["Enter Help Mode first.","While on the S0 screen, press the HEAVY DUTY keypad.","Use NORMAL keypad…
One-Watt Standby Mode (NSC Controls)Press and hold Cancel and Less
Oven Temperature Adjustment (Hidden Function)1
Quick Test Mode["Press and hold CANCEL and BROIL pads simultaneously for 3 seconds.","Once the control has entered…
Quick Test Mode (EOC III Controls)1
Quick Test Mode (H1 Controls - Convection Model)1
Quick Test Mode (H1 Controls - Non-Convection Model)1
Quick Test Mode (H2/H2.5 Controls)1
Quick Test Mode (H3 Controls)1
Quick Test Mode (M1/M2 Controls)1
Quick Test Mode (NSC Non-Self Clean Controls)1
Sabbath ModeHold CLOCK pad for 3 to 5 seconds to activate Sabbath mode.
Service Mode (EOC III Controls)1
Setup Mode["PD Models
Temperature Display Toggle (°F/°C)Press and hold CANCEL and BAKE pads for 3 to 5 seconds
Test Mode (UH Controls)1
USB Menu["Enter Help Mode first.","While on the USB screen, press the HEAVY DUTY keypad.","Use NORMAL…
Wi-Fi Menu["Enter setup mode and navigate to the F0 screen.","Press the HEAVY DUTY keypad to enter Wi-Fi…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana refrigerator models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass