mypros+
Model reference

Amana TR-19D

Refrigerator

2 documents39 error codes13 service modes

Available documentation

Installation Guide

  • Instrucciones de instalacion44 pg
    Covers this model
  • Installation Instructions4 pg
    Covers this model
MyPros+ Max

Diagnose your Amana TR-19D.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (39)

CodeMeaning
F0 E7Control board recognized line voltage below 90 VAC.F0E0No fault detected.F0E2Over suds condition detected; suds prevent the basket from spinning up to speed…F0E4High water temperature (105°F or higher) detected during the rinse cycle.F0E5Off balance load detected during operation.F1 E1ACU (Appliance Control Unit) fault.F1 E7ACU voltage input fault.F1E1Main control fault.F1E2Motor control fault on the motor control section of the main control.F2 E1Lower dryer keypad is sensed pressed for 60 seconds.F2 E2Upper dryer keypad is sensed pressed for 60 seconds.F2E1Stuck key; one or more keys on the User Interface were actuated for 15…F2E3Switch mismatch; the switches do not match the console or are not operating…F3E1Pressure system fault; the main control detects an out of range pressure signal.F3E2Inlet water temperature fault; the inlet thermistor is detected to be open or…F5 E1Lower dryer door circuit error.F5 E6Upper dryer door circuit error.F5E1Lid switch fault; lid is in locked state but lid switch is open, control not…F5E2Lid lock fault; lid lock has not moved into locked position or motor cannot be…F5E3Lid unlock fault; lid lock has not moved into unlocked position or motor cannot…F5E4Lid not opened between cycles; user presses START after several consecutive…F7 E6Lower dryer motor circuit error.F7 E7Upper dryer motor circuit error.F7 E8Lower dryer motor sense error.F7 E9Upper dryer motor sense error.F7E1Basket speed fault; main control cannot determine speed of basket, or speed…F7E5Shifter fault; main control cannot determine position of shifter.F7E6Motor fault; indicates an open clockwise or counterclockwise circuit of the…F7E7Motor unable to reach target RPM; basket speed sensor detects that target RPM…F8E1No fill or long fill; water level does not change for a period of time or water…
View all 39 error codes
F8E3Overflow condition; main control senses water level that exceeds the washer's…F8E5Hot and cold inlet hoses are reversed.F9E1Long drain; water level does not change after the drain pump is on for 10…FC E1Model/Serial number not programmed on control.FC E4USB stick failure (USB full, not detected, or not accessible).FC E5Software uploaded from USB stick does not match to model number of machine.FP E1Coin 1 circuit error.FP E2Coin 2 circuit error.FP E3Card reader communication error.

Service modes (13)

  • Automatic Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until only the 'Spin' LED is…
  • Calibration Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until only the 'Rinse' LED is…
  • Diagnostic Mode["Enter Setup Mode first.","While in any of the set-up codes 1 through 6 (or while dAS displays if…
  • Fault Code Display Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until only the 'Done' LED is…
  • Help Mode["Enter Setup Mode first.","Navigate to special pricing option step 2.XX.","Press the HEAVY DUTY…
  • Manual Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until 'Spin' and 'Done' LEDs are…
  • Model/Serial Number Menu["Enter Help Mode.","While on the S0 screen, press the HEAVY DUTY key.","Use NORMAL key to advance…
  • Service Diagnostic Test Modes (Entry)["Ensure washer is in standby mode (plugged in with all indicators off).","Wait 10 seconds after…
  • Setup Mode["Coin Models
  • Software Version Display Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until 'Rinse', 'Spin', and 'Done'…
  • Tachometer Verification Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until 'Wash' and 'Done' LEDs are…
  • UI Test Mode["Enter Service Diagnostic Test Modes.","Turn cycle selector knob until 'Rinse' and 'Spin' LEDs are…
  • USB Menu["Enter Help Mode.","While on the USB screen, press the HEAVY DUTY key.","Use NORMAL key to advance…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Amana refrigerator models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass