Model reference
Bakers Pride 300
Dishwasher
42 error codes8 service modes
MyPros+ Max
Diagnose your Bakers Pride 300.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (42)
CodeMeaning
34Capacitive sensor values read by the Main Board are not within the predefined…35Capacitive sensor assembly communication problem with main control board (500 &…41Door opened at cycle start.42Door closed sensing error.51Drum motor relay error.52Drum motor start sensing error.53Drum motor centrifugal switch error.54Drum motor sensing error.61Heater relay error.63Heater short error.64Heater open error.65Thermostat open.67Thermal/Heater sensing error (Only for Dual Coil).71NTC1 (OPEN) error.72NTC1 (SHORTED) error.73NTC2 (OPEN) error.74NTC2 (SHORTED) error.91User Interface communication problem with main board.92User Interface mother board protocol mismatch.93MCF checksum error.94CCF checksum error.97Missing program on CTF error.9CUser Interface configuration checksum error.9EUser Interface touch sensor not working.F1Ventilation blocked error.F10Electronic oven control failure.F11Electronic oven control failure (shorted key).F13Electronic oven control failure.F14Electronic oven control failure.F15Electronic oven control failure.View all 42 error codes
F3No Gas Error.F30Electronic oven control failure (oven temperature sensor open or shorted).F31Electronic oven control failure (oven temperature sensor open or shorted).F6Safety reset error.F90Electronic oven control failure (door lock motor circuit failure).H1/B1Power supply frequency out of range.H2/B2Power supply amplitude out of range (too HIGH).H3/B3Power supply amplitude out of range (too LOW).H4/B4Line wiring error.HA/BDLine safe relay short circuit error.HE/BELine safe error.HF/BFLine safe sensing error.
Service modes (8)
- Continuous bake / 12-hour energy saving toggle["Press and hold the 'Timer on-off' key for approximately 6 seconds to toggle between continuous…
- Demo Mode["1. Press power and look for console to light up.","2. For Rotary Dial
- Diagnostic Mode["1
- Factory Default Reset["1
- Oven temperature calibration adjustment["Press the 'Bake' key.","Set temperature to 550°F (287°C) by pressing and holding the UP arrow…
- Recall Last Error Code["1
- Silent mode (control panel beep disable)["Press and hold the 'Start time' key for 6 seconds until the control beeps, then release."]
- Temperature display mode change (°F/°C)["Press the 'Broil' key ('--' appears on display).","Press and hold the UP arrow key until 'HI'…
Full entry steps, exit procedures, and test sequences are available in Max.
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax