Model reference

Bosch And Siemens HG2528UC

Range

5 documents27 error codes2 service modes

Available documentation

Service Manual

Technical Service Information Bosch and Siemens Free-standing and Slide-in Ranges12 pg
Covers this model

Bulletin

Hinge Improvement Kits – 687665, 683866, 6838672 pg
Covers this model

Other

HG2528UC manual52 pg
Covers this model
BoardServiceKit2 pg
Covers this model
HDS7152 Fault Code Guide12 pg
Covers this model

MyPros+ Max

Diagnose your Bosch And Siemens HG2528UC.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Bosch And Siemens Range

F1 on my Bosch And Siemens HG2528UC

M+

Meat probe failure detected during TEST

From Service Manual 498333, p.25:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (27)

CodeMeaning

F1Meat probe failure detected during TEST or SERVICE mode.F111Oven runaway F113Runaway oven temperature reaching 950°F while latch is locked F120Any key (except CANCEL) pressed longer than 60 seconds, possibly caused by…F121Touch key voltage out of limits (except CANCEL key)F122Selection mechanism for touch keys faulty F124CANCEL key pressed for more than 60 seconds F125CANCEL key voltage out of limits F131Meat probe not calibrated when probe is in use.F132Shorted meat probe F141Slave micro not functioning F151EEPROM failure or communication circuit failure F153User interface too hot F154Power board too hot F155Cook profile corrupted in EPROM.F160Cooling fan Hall effect feedback not present (SIR F190Power over voltage at power-up F2Oven sensor failure detected during TEST or SERVICE mode.F200Time-out and stop function during production TEST mode F210Range exceeded safe test limits during SERVICE mode F3Warming drawer sensor failure detected during TEST or SERVICE mode.F31Oven temperature sensor failure F32Oven sensor shorted F33Warming drawer sensor failure F34Warming drawer sensor shorted F41Motorized latch will not lock at start of self-clean, or door light switch…F43Motorized latch will not unlock at completion of self-clean.

Service modes (2)

SERVICE modeNot specified in document
TEST modeNot specified in document

Full entry steps, exit procedures, and test sequences are available in Max.

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass