mypros+
Model reference

Bosch And Siemens HGS7282UC

Range

8 documents37 error codes6 service modes

Available documentation

Service Manual

  • gas range service manual116 pg
    Covers this model
  • Technical Service Information Bosch and Siemens Free-standing and Slide-in Ranges12 pg
    Covers this model
  • ServiceManual BoschFSR116 pg
    Covers this model

Bulletin

  • TECHNICAL INFORMATION BULLETIN Bosch Free-standing Range/Slide-in Range Oven Operation Update1 pg
    Covers this model
  • Hinge Improvement Kits – 687665, 683866, 6838672 pg
    Covers this model

Other

  • BoschFreeStandingSlideInRangeSerMan58300000118566116 pg
    Covers this model
  • BoardServiceKit2 pg
    Covers this model
  • HDS7152 Fault Code Guide12 pg
    Covers this model
MyPros+ Max

Diagnose your Bosch And Siemens HGS7282UC.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (37)

CodeMeaning
ER 12MTwisT Control faultER 13MTwisT Control faultER 22MTwisT Control faultER 23MTwisT Control faultER 24MTwisT Control faultER 25MTwisT Control faultER 26MTwisT Control faultER 3MTwisT Control faultF1Meat probe failure detected during TEST or SERVICE mode.F111Oven runawayF113Runaway oven temperature reaching 950°F while latch is lockedF120Any key (except CANCEL) pressed longer than 60 seconds, possibly caused by…F121Touch key voltage out of limits (except CANCEL key)F122Selection mechanism for touch keys faultyF124CANCEL key pressed for more than 60 secondsF125CANCEL key voltage out of limitsF131Meat probe not calibrated when probe is in use.F132Shorted meat probeF141Slave micro not functioningF151EEPROM failure or communication circuit failureF153User interface too hotF154Power board too hotF155Cook profile corrupted in EPROM.F160Cooling fan Hall effect feedback not present (SIRF170Power failure detected.F190Power over voltage at power-upF2Oven sensor failure detected during TEST or SERVICE mode.F200Time-out and stop function during production TEST modeF210Range exceeded safe test limits during SERVICE modeF3Warming drawer sensor failure detected during TEST or SERVICE mode.
View all 37 error codes
F31Oven temperature sensor failureF32Oven sensor shortedF33Warming drawer sensor failureF34Warming drawer sensor shortedF41Motorized latch will not lock at start of self-clean, or door light switch…F43Motorized latch will not unlock at completion of self-clean.F45Motorized latch both locked and unlocked simultaneously (contacts A and B both…

Service modes (6)

  • Service Configuration Mode (FSR3 models 30, 50, 70, 71, 72)["Turn the power on and wait until the display shows the type (ELECTRIC or GAS) and software…
  • SERVICE modeNot specified in document
  • Service Test Program["Place a finger on the cooking mode, temperature, and start zones simultaneously for 5 seconds…
  • Service/Test ProgramPlace a finger on the cooking mode, temperature, and start touch zones simultaneously and hold for…
  • TEST modeNot specified in document
  • Thermostat Calibration (Oven Temp Offset)["Touch cooking mode and keep your finger on it until 'SELECT FUNCTION' appears (about 5…

Full entry steps, exit procedures, and test sequences are available in Max.

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass