Dacor MMDH30S

Available documentation

Error codes (1)

Service modes (11)

• AH Sensor Water Load Cooking Test (Diagnostic Mode)["Ensure oven has been plugged in at least two minutes before testing.","Fill approximately 200…
• Audible Signal Elimination["Touch SETUP/HELP pad once.","Touch SETUP/HELP pad again
• Auto Start["Touch SETUP/HELP pad 4 times
• Control Lock["Touch CONTROL LOCK pad and hold for 3 seconds
• Control Unit AH Sensor Check (Dummy Resistor Test)["Disconnect power supply cord and remove covers.","Open drawer and block it open.","Discharge high…
• Control unit AH sensor verification (dummy resistor test)["Disconnect power supply cord and disassemble per manual.","Open drawer and block it…
• Defrost test["Oven must be fully assembled.","Place one cup of water in the center of the tray in the oven…
• Demonstration Mode["Touch SETUP/HELP pad five times
• End of Cooking Reminder["Touch SETUP/HELP pad three times
• Relay Test["Disconnect power supply cord and remove outer case.","Open door and block it open.","Discharge…
• Sensor cooking diagnostic test (AH sensor water load test)["Ensure oven has been plugged in at least two minutes.","Fill approximately 200 ml (7.2 oz) of tap…

Full entry steps, exit procedures, and test sequences are available in Max.