mypros+
Model reference

GE CDT765

Dishwasher

9 documents28 error codes5 service modes

Available documentation

Service Manual

  • Technical Service Guide101 pg
    Covers this model
  • Owner's Manual - Dishwashers96 pg
    Covers this model
  • GE Dishwasher Control Board Replacement Part Instruction2 pg
    Covers this model
  • Technical Service Guide101 pg
    Covers this model

Service Flash

  • GE Dishwasher Bulletin Nov 2013 DD03 13 14 pg
    Covers this model

Bulletin

  • Service Bulletin DD09-14 - Dishwasher Reports of No Water, Low Water Level1 pg
    Covers this model

Training

  • TB09–13 2012 and later Dishwashers Water on floor under door7 pg
    Covers this model

Job Aid

  • Control Board Replacement - Personality Jumper Configuration2 pg
    Covers this model

Other

  • PTGC20045 En Fr8 pg
    Covers this model
MyPros+ Max

Diagnose your GE CDT765.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (28)

CodeMeaning
F112Key stuck on UI board.F128Low rinse aid level.F144Replace inverter.F145Check AC volts to inverter.F146Replace circulation pump.F147Replace drain pump.F148Replace motor with faulty TCO (thermal cut out).F149Check harness or inverter.F16High water temperature detected.F2Communication failed between main board and UI control.F3Configuration errorF33Door switch error.F34Leak pan detected errorF35Diverter feedback error.F48Turbidity sensor reading high.F49Turbidity sensor reading low.F5Communication failed with inverter.F50Temperature sensor reading high.F51Temperature sensor reading low.F52Turbidity sensor calibration failure.F64Inverter error received.F65Inverter no water detected.F80Absent water flow (turbidity based).F96No water in tub (turbidity based).F97Absent heat source.F98Non-draining sump (turbidity based).F99Minimum wash temperature not met.LEAK DETECTEDThe dishwasher has detected a possible water leak; the dishwasher will drain…

Service modes (5)

  • Control LockPress and hold both the PreSoak and Bottle Wash buttons for 3 seconds to LOCK.
  • Demo Mode
  • Diagnostic Fault Code Display ModeWith dishwasher in Standby Mode (cycle selection mode and not running a cycle), press and hold the…
  • Door Wake Up Mode (Sabbath Mode)Press and hold the START and WASH TEMP buttons for 5 seconds to toggle ON/OFF.
  • Service Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE dishwasher models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass