Model reference
GE GDFS_F
Dishwasher
2 documents27 error codes4 service modes
Available documentation
Service Manual
- Technical Service Guide - Dishwasher97 pg
- Technical Service Guide97 pg
MyPros+ Max
Diagnose your GE GDFS_F.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (27)
CodeMeaning
F112Key stuck on UI control.F128Low rinse aid level detected.F144Replace inverter.F145Check AC volts to inverter.F146Replace circulation pump.F147Replace drain pump.F148Replace motor with faulty TCO.F149Check harness or inverter.F16High water temperature detected.F2Communication failed between main board and UI control.F3Configuration errorF33Door switch error.F34Leak pan detected errorF35Diverter feedback error.F48Turbidity sensor reading high.F49Turbidity sensor reading low.F5Communication failed with inverter.F50Temperature sensor reading high.F51Temperature sensor reading low.F52Turbidity sensor calibration failure.F64Inverter error received.F65Inverter no water detected.F80Absent water flow (turbidity based).F96No water in tub (turbidity based).F97Absent heat source detected.F98Non-draining sump (turbidity based).F99Minimum wash temperature not met.Service modes (4)
- Demo ModeHold START and HEATED DRY for 5 seconds.
- Diagnostic Fault Code Display ModeWith the dishwasher in Standby Mode (Cycle Selection Mode), press and hold the Cycle Select and…
- Service ModeWhile in Diagnostic Fault Code Display Mode
- Service Mode (Load Control)1
Full entry steps, exit procedures, and test sequences are available in Max.
Related GE dishwasher models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass