mypros+
Model reference

GE GLDT696T

Dishwasher

12 documents6 error codes3 service modes

Available documentation

Service Manual

  • GE Built-In Dishwasher with Top Controls Technical Service Guide34 pg
    Covers this model
  • GE Triton Dishwasher Service Mode1 pg
    Covers this model
  • Owner's Manual - Triton XL Dishwashers16 pg
    Covers this model
  • GE Profile Dishwashers Owner's Manual16 pg
    Covers this model
  • Dishwashers Triton™ Profile™ Owner's Manual32 pg
    Covers this model

Bulletin

  • Service Bulletin - Time Remaining Display Does Not Illuminate When Cycle Selections Are Pressed1 pg
    Covers this model
  • Service Bulletin - Water Condenses on the Edge of the Control Panel Above the Door Vent3 pg
    Covers this model
  • Service Bulletin - The Electronic Control Does Not Respond To User Input From The Membrane Switch1 pg
    Covers this model
  • Service Bulletin - Triton Coarse Filter Retaining Studs1 pg
    Covers this model
  • Dishwasher Front Panel Repair Kit1 pg
    Covers this model
  • Service Bulletin DD 02-031 pg
    Covers this model

Training

  • TECHNICAL SERVICE GUIDE Triton XL Dishwashers44 pg
    Covers this model
MyPros+ Max

Diagnose your GE GLDT696T.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (6)

CodeMeaning
ALL_FLASH_BEEPControl error indicated by all status lights (SENSING, WASHING, RINSING…E0Thermal sensor cut (open circuit in thermistor).E1Thermal sensor short (short circuit in thermistor).RINSING_FLASHControl error indicated by the RINSING status light flashing along with a…SENSINGCleanSensor errorWASHING_RINSING_FLASHSTART/RESET pad has been pressed

Service modes (3)

  • Factory Diagnostic Mode["Turn the dishwasher off and make sure no LEDs are lit.","Disconnect power to the…
  • Service Test Mode["Turn the dishwasher off and make sure no LEDs are lit.","Disconnect power to the…
  • SmartDispense Water Hardness Calibration["Close and latch the door (lights on, dishwasher not running).","Press the COOKWARE and DELAY…

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass