mypros+
Model reference

GE PDT775SYN0FS

Dishwasher

1 document33 error codes2 service modes

Available documentation

Service Manual

  • PDT775SYN2 Service Manual2 pg
    Covers this model
MyPros+ Max

Diagnose your GE PDT775SYN0FS.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (33)

CodeMeaning
CFEContinuous fill error; consecutive signals from pressure sensor detect high…F128Low rinse aid detected in the unit.F151Continuous flow fault; water level reaches flood stage several times and has to…F16High water temperature detected.F32Pressure sensor reading falls out of range or is unplugged.F33Pressure sensor reading too low during calibration.F34Water present or detected in the drain pan (floor protect pan detected error).F35Diverter feedback error; feedback communication from diverter is not present or…F36CSM (Current Sense Module) has tripped.F48Turbidity sensor reading high (possible open on sensor).F49Turbidity sensor reading low (possible short on sensor).F5Inverter found on incorrect MC personality; MC personality has not been…F50Temperature sensor high; sensing or stuck at a high reading.F51Temperature sensor low; sensing or stuck at a low reading.F52Turbidity sensor did not successfully calibrate.F58Thermistor is not functional.F59Thermistor is not functional.F6Communication lost with wireless module (on some models).F60Heater relay is stuck.F62Dry fan not working properly.F64Inverter-specific error detected.F65Inverter did not detect water; will not allow heater to turn on (failsafe).F66Dry heater TCO fault; heater or a TCO is open, temperature is out of range.F80Absent water flow (turbidity based); water flow not detected in unit.F86No fill failure; pressure sensor does not sense filling.F87Thermistor install fault; thermistor did not see the proper heat rise during…F96No water in tub (turbidity based); water not detected by turbidity sensor.F97Absent heat source; Calrod (heater) not detected by machine control.F98Non-draining sump (turbidity based); unit not draining or not being detected by…F99Minimum wash temperature of 120°F was not reached in 3 of the past 5 wash…
View all 33 error codes
H20No water detected; internal water level does not change, cycle is cancelled…PrFPressure sensor failure; pressure sensor signal is undetectable or irrational…PrSPressure sensor error; pressure sensor signal is undetectable or irrational…

Service modes (2)

  • Error Code Display ModeWhen the dishwasher is in Standby Mode (Cycle Selection Mode), press and hold the Cycle Select (or…
  • Service ModeCan only be entered during Error Code Display Mode

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass