GE PDW9000

Available documentation

Service modes (20)

• Consumer Purge Cycle1. Make sure Pre-wash, Added Heat, and Heated Dry LEDs are off. 2. Press Heated Dry and Cookware…
• Control lock["Press and hold HEATED DRY button for 3 seconds
• Control Panel Lock/Unlock["Press and hold the HEATED DRY pad for 3 seconds to lock the controls (light above LOCK pad will…
• Demo ModePress the Cookware pad (Down arrow on Top Control models) and Added Heat pad simultaneously for 5…
• End-of-cycle beep toggle["Press HEATED DRY button 5 times within 3 seconds.","Three beeps will sound to indicate the…
• Factory Test Mode1
• LOW DETERGENT indicator toggle["Press ADDED HEAT button 5 times within 3 seconds.","Three beeps will sound and the LOW DETERGENT…
• Service ModePDW8900 Series
• SmartDispense water hardness calibration (12-button front panel with 3-digit display)["Close and lock the door (lights on, dishwasher at rest).","Press COOKWARE and DELAY HOURS buttons…
• SmartDispense Water Hardness Calibration (12-Button Front-Control Models With 3-Digit Display)["Close and latch the door (lights on, dishwasher not running).","Press the COOKWARE and DELAY…
• SmartDispense water hardness calibration (7-button front panel with 3-digit display)["Open the door and press any button (other than START) to activate the lights.","Press Up arrow…
• SmartDispense Water Hardness Calibration (7-Button Front-Control Models With 3-Digit Display)["Open the door and touch a pad (other than START) to turn lights on.","Press the Up Arrow Pad and…
• SmartDispense water hardness calibration (models without 3-digit display, front controls)["Close and lock the door (lights on, dishwasher at rest).","Press COOKWARE and DELAY HOURS buttons…
• SmartDispense water hardness calibration (models without 3-digit display, top controls)["Open the door and press any button to activate the lights.","Press Up arrow and DELAY HOURS…
• SmartDispense Water Hardness Calibration (Models Without a 3-Digit Display - Front Controls)["Close and latch the door (lights on, dishwasher not running).","Press the COOKWARE and DELAY…
• SmartDispense Water Hardness Calibration (Models Without a 3-Digit Display - Top Controls)["Open the door and touch a pad to turn lights on.","Press the Up Arrow Pad and DELAY HOURS pad at…
• Toggle End-of-Cycle Audible Signal["Press the HEATED DRY pad 5 times within 3 seconds.","A triple beep will sound to indicate the…
• Toggle LOW DETERGENT LED (when not using SmartDispense)["Press the ADDED HEAT pad 5 times within 3 seconds.","You will hear 3 beeps; then the light will…
• Turbidity Sensor CalibrationMust be entered within 2 minutes of power up
• Water Hardness Calibration ModePDW8900

Full entry steps, exit procedures, and test sequences are available in Max.