Model reference

GE ZBD6920V

Name: GE ZBD6920V
Brand: GE

Dishwasher

6 documents15 service modes

Available documentation

Service Manual

Technical Service Guide - Top-Control Stainless Steel Tub Dishwashers41 pg
Covers this model
GE Appliances Technical Service Guide Top-Control Stainless Steel Tub Dishwashers41 pg
Covers this model
GE Appliances Technical Service Guide - Top-Control Stainless Steel Tub Dishwashers41 pg
Covers this model
Top-Control Stainless Steel Tub Dishwashers Technical Service Guide41 pg
Covers this model

Training

New Top Control Door Design Platform72 pg
Covers this model
GE Dishwasher SS Top Control Dishwasher Training Presentation72 pg
Covers this model

MyPros+ Max

Diagnose your GE ZBD6920V.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·GE Dishwasher

How do I access the service manual for ZBD6920V?

M+

Accessing service documentation

1.I have the service manual for this model. Are you seeing a specific error code or symptom?

2.I can walk you through diagnostic mode entry, wash motor tests, and fill/drain circuit checks.

3.For component testing, I can reference the exact resistance specs and wiring from the service manual.

Part WD19X23874

Drain pump assembly

Service modes (15)

Consumer Purge Cycle["Make sure STEAM, ADDED HEAT, and HEATED DRY LEDs are off.","Press HEATED DRY button and SELECT…
consumer_purge_cycle["Make sure STEAM, ADDED HEAT, and HEATED DRY LEDs are off.","Press HEATED DRY button and SELECT…
Control Replacement/Calibration Mode (test/00)["The dishwasher enters into the test/00 calibration mode when the unit is first powered on.","The…
control_replacement_calibration["The dishwasher enters into the test/00 calibration mode when the unit is first powered…
Factory Test Mode["Initiates automatically upon installation of a new main control board.","All LEDs light (10…
factory_testInitiates automatically upon installation of a new main control board when powered on. Sequence
factory_test_mode["Initiates automatically upon installation of a new main control board.","All LEDs light (10…
service1
Service Mode["Put the dishwasher in standby mode.","Press the HEATED DRY and SELECT CYCLE buttons…
service_mode["Put the dishwasher in standby mode.","Press the HEATED DRY and SELECT CYCLE buttons…
Turbidity Sensor Manual Calibration["Press the START/RESET button 100 times."]
turbidity_sensor_calibration["If the turbidity sensor is replaced without replacing the control board, press the START/RESET…
turbidity_sensor_manual_calibration["Press the START/RESET button 100 times."]
Water Hardness Calibration Mode["Dishwasher must be in standby mode.","Press the SELECT CYCLE button to activate the tactile…
water_hardness_calibration["Dishwasher must be in standby mode.","Press the SELECT CYCLE button to activate the tactile…

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass