mypros+
Model reference

GE ZDT985SINCII

Dishwasher

1 document45 error codes4 service modes

Available documentation

Service Manual

  • Technical Service Guide83 pg
    Covers this model
MyPros+ Max

Diagnose your GE ZDT985SINCII.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (45)

CodeMeaning
888CSM (Current Sense Module) is tripped and dishwasher is non-responsive; all…CFEContinuous fill errorF1Communication error between the User Interface (UI) board and the Main Control…F112Key stuck fault.F128Low rinse aid level.F144Inverter fault.F145Inverter fault.F146Circulation pump fault.F147Drain pump fault.F148Motor TCO fault.F149Motor temperature fault.F150Inverter phase current fault.F151Continuous flow faultF16High water temperature detected.F32Water level sensor invalid reading.F33Low pressure sensor reading.F34Leak pan detected error.F35Diverter feedback communication is not present or not correct.F36CSM (Current Sense Module) tripped / CSM lock out.F48Turbidity sensor reading high.F49Turbidity sensor reading low.F5Inverter found on incorrect main control personality.F50Temperature sensor reading high.F51Temperature sensor reading low.F52Turbidity sensor calibration failure.F58Thermistor is not functional.F59Thermistor is not functional.F6Communication lost with wireless module.F60Heater relay stuck fault.F61CSM check failed.
View all 45 error codes
F62Dry fan fault.F63Flood condition faultF64Inverter error received.F65Inverter no water detected.F66Dry heater TCO faultF80Absent water flow (turbidity based).F86No fill failure.F87Dry heater diagnostic fault.F96Ignore fault.F97Absent heat source.F98Non-draining sump (turbidity based).F99Minimum wash temperature not met.H2ONo water detectedPrFPressure sensor failure, cycle cancelled.PrSPressure sensor signal undetectable or irrational, cycle cancelled.

Service modes (4)

  • Consumer Error ModeWith dishwasher in Standby Mode (not running a cycle but awake), press and hold the Cycle Select…
  • Demo Mode ExitTo exit Demo Mode, hold SELECT CYCLE (or the first button on the left) and DRY at the same time for…
  • Sabbath Mode / Door Wake Up ModePress and hold the Start and Boost pads for 5 seconds, close the door and wait 3 minutes for the…
  • Service Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass