GE DPGT650G

Available documentation

Error codes (3)

Service modes (18)

• Control Lock["Press and hold Dry Level and Temp buttons simultaneously for 3 seconds.","Display shows 'cl' when…
• Service Mode["Ensure the dryer is in idle state (no display on SSD).","Press and hold 'Less Time' and 'Wrinkle…
• T1 - LED Component Check["Enter Service Mode (display shows 't1').","Press Start button
• T1 – LED Component Check["Enter Service Mode (display shows 't1').","Press Start to begin test.","Display toggles between…
• T2 - Software Revision["Navigate to t2 using Cycles button.","Press Start
• T2 – Software Revision["Navigate to T2 using Cycles button.","Press Start to begin test.","Display toggles between…
• T3 - Dryer Motor Test["Navigate to t3 using Cycles button.","Press Start
• T3 – Dryer Motor Test["Navigate to T3 using Cycles button.","Press Start to begin test.","Display shows '00' and drum…
• T4 - Door Switch Test["Navigate to t4 using Cycles button.","Press Start
• T4 – Door Switch Test["Navigate to T4 using Cycles button.","Press Start to begin test.","Display shows 'dE' if door is…
• T5 - Humidity Sensor Test (Sensor Rods)["Navigate to t5 using Cycles button.","Press Start
• T5 – Humidity Sensor Test["Navigate to T5 using Cycles button.","Press Start to begin test.","Display shows a value from 30…
• T6 - Heater 1 and Outlet Thermistor Test["Navigate to t6 using Cycles button.","Press Start
• T6 – Heater 1 and Outlet Thermistor Test["Navigate to T6 using Cycles button.","Press Start to begin test.","Heater 1 turns on.","Display…
• T7 - Heater 1 and Heater 2 (Gas On) Test["Navigate to t7 using Cycles button.","Press Start
• T7 – Heater 1 and Heater 2 Test["Navigate to T7 using Cycles button.","Press Start to begin test.","Heater 1 and Heater 2 both…
• T8 - Error Codes["Navigate to t8 using Cycles button.","Display shows 't8' then shows the last error code saved by…
• T8 – Error Codes (Stored Fault History)["Navigate to T8 using Cycles button.","Display shows 't8' then the last saved error code for 1…

Full entry steps, exit procedures, and test sequences are available in Max.