Model reference
GE XL44
Range
6 documents11 error codes9 service modes
Available documentation
Service Manual
- XL44™ Self-Cleaning Gas Ranges Owner's Manual and Installation Instructions56 pg
- Technical Service Guide New 30" XL44™ Series Ranges Featuring True Temp™ Cooking34 pg
- XL44 Self-Cleaning Gas Convection Ranges Technical Service Guide30 pg
- Technical Service Guide GE Consumer Service Training XL44 TM Self-Cleaning Gas Convection Ranges30 pg
Training
- Technical Service Guide New 30" XL44™ Series Ranges Featuring Truetemp Cooking34 pg
- TECHNICAL SERVICE GUIDE 30" Free-Standing Gas Range with "Gourmet Burner"20 pg
MyPros+ Max
Diagnose your GE XL44.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (11)
CodeMeaning
F—Function error code indicated by 'F' followed by a number or letter flashing in…F0Shorted CLEAR/OFF key detected by control.F1Stuck key pad or transistor failure; may mean relay is turned on.F2Control senses oven temperature above 615°F during BAKE (or above 915°F during…F3Open sensor; sensor resistance exceeds 2900 ohms during bake, broil, or clean.F4Shorted sensor; sensor resistance is less than 2900 ohms during bake, broil, or…F5Loss of relay drive circuit.F7Any shorted membrane key other than CLEAR/OFF detected by control.FCProblem with door lock circuit such as pinched wires between control and door…FFDoor motor safety circuit fault.FFFControl error, failed EEPROM.Service modes (9)
- ERC Fault Code Memory Display["With display showing time of day, simultaneously press the COOKING TIME, DELAY START, and number…
- ERC On-Board Diagnostic Test Mode["Remove power to the appliance for approximately 8 seconds, then reapply power.","Simultaneously…
- Fault Code Memory DisplayRefer to page 14 of the technical service guide for the fault code memory display procedure.
- Lock Motor Cycle Test["Enter ERC Diagnostic Test Mode (remove power 8 seconds, reapply, press COOKING TIME + DELAY START…
- On-Board Diagnostic Test Mode1
- On-Board Diagnostic TestsRefer to page 16 of the technical service guide for on-board diagnostic test entry procedures.
- Sales Mode1
- Special Features (SF) Mode["With display showing time of day, press the BAKE and BROIL HI/LO pads at the same time for 2…
- Special Features ModePress the BAKE and BROIL HI/LO pads at the same time for 2 seconds until the display shows 'SF'.
Full entry steps, exit procedures, and test sequences are available in Max.
Related GE range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass