mypros+
Model reference

GE WPRB9220

Washer, Dryer

1 document30 error codes1 service mode

Available documentation

Training

  • Appliance Diagnostic Modes Laundry128 pg
    Covers this model
MyPros+ Max

Diagnose your GE WPRB9220.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (30)

CodeMeaning
E10EOL Water Inlet Test code not cleared at End Of Line factory test.E11EOL Agitation Test Incomplete, code not cleared at End Of Line factory test.E12EOL Drain Test Incomplete, code not cleared at End Of Line factory test.E13EOL Spin Test Incomplete, code not cleared at End Of Line factory test.E20Low Level Pressure Switch Error in the fill system.E21High Level Pressure Switch Error in the fill system.E30Clog Detected in the drive system.E31Pump Timeout in the drive system.E32Pump Current Detection Circuit Error in the drive system.E40VSD (Variable Speed Drive / Inverter) Health Error.E41VSD Power/Communication Error in the drive system.E42VSD Noisy Communication Error in the drive system.E43Excessive Brake Time detected in the drive system.E46VSD No Speed Signal in the drive system.E47VSD Heat Sink Over Temperature in the drive system.E48VSD Motor Short Circuit detected in the drive system.E49VSD Drive Overload in the drive system.E4AVSD Line Voltage Failure in the drive system.E4BVSD Drive Reset, low voltage (most likely cause is a brownout).E4CVSD Temperature Sensor Failure in the drive system.E4DVSD Ram Error in the drive system.E50EEPROM Read/Write Failure on the electronic control.E60Lid Switch Error detected by sensors.E61Speed Sensor Error detected by sensors.E62Lid Lock Error detected by sensors.E63Excessive Radial Acceleration detected.E64Excessive Axial Acceleration detected.E65Accelerometer No Signal Error.E66Water Temperature Sensor Open circuit.E67Water Temperature Sensor Short circuit.

Service modes (1)

  • Service Mode["Turn the unit off at the POWER pad.","Remove power to the unit by unplugging it for 15…

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE washer, dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass