Model reference

Haier SMHWD1000-1

Washer

1 document12 error codes

Available documentation

Service Manual

Automatic Drum Washing Machine Service Manual30 pg
Covers this model

MyPros+ Max

Diagnose your Haier SMHWD1000-1.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Haier Washer

E1 on my Haier SMHWD1000-1

M+

The required water level is not reached

From Service Manual 758995, p.47:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WR55X10942

Main control board

Error codes (12)

CodeMeaning

E1The required water level is not reached within 8 minutes.E2Drainage error, water not emptied within 5 minutes.E3Water level exceeds protective value.E4Motor overheat protection or motor is damaged.E5Water level is abnormal in the drying process.E6The water level sensor circuit is short cut or open.E7The temperature of air vent is abnormal (heater circuit issue).E8The dry temperature sensor is short cut or open.E9Door is not properly shut 20 seconds after program is started.EASpin lopsidedly (unbalanced load during spin).EbDoor is not closed before starting program.ECThe memory function (EEPROM) has failed.

Related Haier washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass