mypros+
Model reference

Jenn-Air DW961UQB

Dishwasher

1 document17 error codes13 service modes

Available documentation

Service Manual

  • Jenn-Air Dishwasher Service Manual180 pg
    Covers this model
MyPros+ Max

Diagnose your Jenn-Air DW961UQB.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (17)

CodeMeaning
00Beginning of error display mode; no errors detected by the controller.1F0Wash arm sensor error; five cycles in a row concluded with a blocked wash arm…1F1Conductivity fault; a bad conductivity sensor reading has occurred.1F2High limit thermostat tripped; a temperature above 155°F (or 185°F per…1F3Communication problem; control and sensor pack communications not operating…1F4Cold water problem; water below 90°F is being detected at the temperature…1F5Current sensor bad; the controller has sensed that the current sensor is not…F0Control board error; an error with the controller has been sensed.F1Motor fault; motor current not changing/not detected.F2Heater fault; heater current not changing/not detected.F3High current error; electrical current within the machine is higher than normal.F4Detergent fault; no conductivity change detected in the main wash for 10 cycles.F5Rinse aid fault; an error with the rinse aid dispensing has been sensed.F7Turbidity sensor fault; a bad turbidity sensor reading has occurred.F8Wash arm fault; an error with the wash arm rotation system has been sensed.F9Thermistor fault; a bad temperature sensor reading has occurred.PFPower failure occurred during a cycle; options selected before the failure will…

Service modes (13)

  • Automatic Function Test (DW961UQ)Press initial sequence
  • Circuit Board Test (DW960/DW980 - Original)Press initial sequence
  • Circuit Board Test (DW960/DW980 - Series A5 and later)Press initial sequence
  • Circuit Board Test (DW961UQ)Press initial sequence
  • Dishwasher Function Test (DW960/DW980)Press initial sequence
  • Error Fault Code Display (DW1000)Press initial sequence
  • Functional Test Mode (DW1000)Press initial sequence
  • Intelli-Bump (DW1000 Sensor Start adjustment)Press LOCK, CANCEL, CANCEL, SANI SCRUB
  • Manual Function Test (DW960/DW980 - Series A5 and later)Press initial sequence
  • Manual Test (DW961UQ)Press initial sequence
  • Manual Test Mode (DW1000)Press initial sequence
  • Rapid Time Down Test (DW960/DW980)No initial sequence required
  • Rapid Time-Down Mode (DW961UQ)Select a cycle, then within one minute press the selected cycle key again and the AccuTemp key…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Jenn-Air dishwasher models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax