Model reference
Jenn-Air S125-C
Range
7 documents31 error codes4 service modes
Available documentation
Service Manual
- Electric Range Service Manual100 pg
Tech Sheet
- TECH SHEET - 9754365 - Rev A8 pg
- Tech Sheet 97543654 pg
- TECH SHEET - KitchenAid Range KESH307HBS68 pg
Other
- ER001 00 .pdf100 pg
- Service Manual - 16000446.pdf99 pg
Installation Guide
- Installation Instructions32 pg
MyPros+ Max
Diagnose your Jenn-Air S125-C.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (31)
CodeMeaning
F0 E0No fault found.F1Element relay circuitF1 E2Lost communication with power board.F1 E3Configuration jumper change; freestand, electric switches or P3 pins 1 to 5…F1 E4Oven sensor not calibrated.F1 E5Meat probe not calibrated.F1 E6Display board EPROM access failure.F1 E7Power board EPROM access failure.F1 E8Improper keypad feedback from power board supply lift.F1 E9Unstable keyboard gain.F1 EAExceeded stack warning level.F2Excessive cavity temperatureF2 E0User is cleaning too long or keypad is disconnected.F2 E1Cancel key invalid.F2 E3Key held down too long or keyboard short or spill on switch surface.F3Oven temperature sensorF3 E0Oven sensor open circuit.F3 E3Shorted oven sensor.F3 E4Oven temperature too high (runaway condition).F4Oven temperature sensorF4 E0Meat probe shorted (less than 1500 ohms).F5Shorted temperature probe, jack or harness.F5 E1Self clean latch not locking.F5 E5Self clean temperature not achieved after 30 minutes.F5 E7Door unlocked but will not unlatch during clean cycle.F6Main control board shorted (only time of day and minute timer will work).F7Clean/lock switch assembly shorted or open, or lock motor still runs.F7 E0Invalid latch switch reading.F7 E1Invalid door switch reading.F8Door lock motor inoperative or open wiring to motor.View all 31 error codes
Service modes (4)
- End of Service Test Sequence (Convection Units)["Connect unit to power, set power ON and wait until CONTROL LOCK clears and display shows PF…
- End of Service Test Sequence (Non-Convection Units)["Connect unit to power, set power ON and wait until CONTROL LOCK clears and display shows PF…
- Fast TestOn power up of the control, press and hold the COOK TIME key for at least 100 ms
- Thermostat Calibration (Electronic Models)1
Full entry steps, exit procedures, and test sequences are available in Max.
Related Jenn-Air range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass