Model reference
Kenmore 1547
Garbage Disposal
40 error codes13 service modes
MyPros+ Max
Diagnose your Kenmore 1547.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (40)
CodeMeaning
ASAmbient thermistor sensor located in the remote control has failed.CdDisplayed once the program has been entered, START/CANCEL is pressed, and after…CEGeneral error or malfunction detected by the dishwasher.CLDisplayed when wash cycle has been completed and SANITIZE was not selected or…ErGeneral error or malfunction detected by the dishwasher.Er 01Leak DetectorEr 02Thermistor/turbidity module has failed.Er 03Wash pump is not operating.Er 04Drying damper is not operating.Er 05During the dry cycle, the control board does not receive proper speed feedback…Er 06During the dry cycle, the control board does not receive proper speed feedback…Er 07During drain mode, the control board does not receive proper position feedback…Er 08Control board has verified a tactile or touch switch on the user interface is…Er 09Communication failure between main user board and power supply.Er 10Failure in the mains power relay.Er 11Drain valveEr 12Drain valve is running when it should be off.Er 13System wideEr 14System ErrorER/CEConfiguration Error.ER/ERSwitch Failure.ER/uFFan not running.ER/uoVent will not close.ESEvaporator thermistor sensor has failed.F1Shorted keypad, corrupted internal checksum, or potential runaway oven…F10Runaway oven temperature condition detected.F11Shorted keypad detected.F13Bad micro identification or bad EEPROM identification/checksum error.F3RTD sensor probe failureF30Open RTD sensor probe connection detected.View all 40 error codes
F31Shorted RTD sensor probe connection detected.HdIndicates a water heat delay is in progress.HOWater heating delayHSHeat thermistor sensor has failed (heat capable models only).LORinse agent lowLocChild Lock is engaged; all buttons except AIR DRY are disabled and no new…PFPower failure detectedSADisplayed when SANITIZE option was selected and dishwasher has reached sanitize…uFGeneral error or malfunction detected by the dishwasher.uoGeneral error or malfunction detected by the dishwasher.
Service modes (13)
- Child LockPress and hold the AIR DRY touchpad for 3 seconds to lock controls.
- Child Lock ControlsWith the door latched, press and hold the RINSE ONLY pad (some models) or the NO HEAT DRY pad (some…
- Control LockPress and hold the RINSE ONLY or AIR DRY pad for 3 seconds.
- First Use InitializationPress and hold SANITIZE touchpad for 8 seconds before first use.
- Ice Maker Test Cycling (mechanical ice maker)Remove cover by inserting screwdriver in notch at bottom and prying cover from housing
- Ice Maker Test Cycling (momentary contact switch type - 240389016/240389618)Press the momentary contact on the ON/OFF switch for approximately 15 seconds
- Initial Setup / Normal Operating Mode ResetPress and hold the Sanitize touchpad for 8 seconds.
- Manual Defrost Initiation (Counter Depth Side-by-Side with ADC - 241532603)Press and hold the Freezer temperature UP (WARMER) key while pressing the Fresh Food temperature…
- Manual Defrost Initiation (Top Mount models with Electronic Defrost Control)Depress the fresh food light switch 5 times in 6 seconds (light bulb must be working).
- Oven CalibrationSet the electronic oven control for normal baking at 350°F
- Oven Temperature Adjustment1
- Reset to Normal Operating ModeHold down SANITIZE touchpad for 8 seconds.
- Water/Service TestWhile in power failure or idle mode, simultaneously press the DRY/AIR DRY and START/CANCEL pads for…
Full entry steps, exit procedures, and test sequences are available in Max.
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax