LG LP91A

Available documentation

Service modes (19)

• ADC Calibration - Component["Change input to Component1 or 2 mode","Input Component 480i@60Hz 100% Color Bar YPbPr signal…
• ADC Calibration - RGB["Change input to RGB mode","Input PC 1024x768@60Hz Horizontal Color Bar signal (MSPG-925F Model
• Adjustment Mode["Press ADJ key on remote control","Enter password
• Check SW Version["Push In-Start key on adjustment remote controller","Check 'SW VER
• DDC Adjustment Mode (White Balance)["Set command delay time to 50ms","Enter DDC adjustment mode at the same time as heatrun mode by…
• EDID Download - 2nd Method["Verify tool option is correct","Press ADJ key","Move to EDID D/L and press right direction key…
• EDID Download - RS-232C Command["Send command
• EDID Download (Method 1 - via Tool Option)["EDID data is automatically downloaded when adjusting Tool Option2","Push Enter key after…
• EDID Download (Method 2 - Manual)["Verify tool option is correct","Press ADJ key","Move to EDID D/L and press right direction key…
• EDID Download (RS-232C command)["Send RS-232C command
• ISP Tool Software Download (via D/L Jig)["Connect download jig to D-sub (RGB) jack","Execute ISP Tool program
• Software Download via D/L Jig (ISP Tool)["Connect download jig to D-sub (RGB) jack","Execute ISP Tool program (Mstar ISP utility)","Click…
• Software Download via USB Memory Stick["Insert USB memory stick into USB port","SW Version is automatically detected","S/W download…
• SW Version Check["Push In-Start key on Adjust remote controller","Check SW VER
• Tool/Area Option Adjustment["Use IN-START key on adjustment remote control","Change Tool option and Area option values per…
• USB Software Download (Service Mode)["Insert USB memory stick into USB port","SW Version is automatically detected","S/W download…
• White Balance Adjustment (Automatic via DDC)["Set command delay time to 50ms","Enter DDC adjustment mode at the same time as heat-run mode when…
• White Balance Adjustment (Manual)["Select white pattern of heat-run by pressing POWER ON key on adjustment remote control","Operate…
• White Balance Manual Adjustment["Select white pattern of heat-run by pressing POWER ON key on adjustment remote control","Operate…

Full entry steps, exit procedures, and test sequences are available in Max.