mypros+
Model reference

Magic Chef 85TB-3BK

Cooktop

8 documents57 error codes22 service modes

Available documentation

Tech Sheet

  • Instruction Sheet - 9753053 - Rev A8 pg
    Covers this model
  • techsheet 445655610 pg
    Covers this model
  • Tech Sheet – do not Discard10 pg
    Covers this model
  • TECH SHEET – KDRP467KSS05 KA Range10 pg
    Covers this model
  • Instruction Sheet - Tech Sheet6 pg
    Covers this model
  • Tech Sheet - 4454079 - Rev B4 pg
    Covers this model

Service Manual

  • Self-Cleaning Slide-In Gas Ranges Job Aid68 pg
    Covers this model

Other

  • 432250068 pg
    Covers this model
MyPros+ Max

Diagnose your Magic Chef 85TB-3BK.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (57)

CodeMeaning
:Power failure indicationF0Default F codeF0 E0No error(s) found.F01Temperature sensor opened (open circuit in oven temperature sensor).F02Welded element relays (element relay contacts stuck closed).F03EEPROM error in the electronic control.F05Door or latch problems (mechanical or electrical failure in door latch…F06Electronic control malfunction.F0E0No failure present (informational code displayed when CANCEL/OFF is held for 5…F1Electronic control malfunction.F1 E0EEPROM communications error.F1 E1EEPROM checksum failure.F1 E2UL A/D error(s).F1 EOEEPROM communications failure.F1-E0Key held down too long or key is shorted.F1-E1Keypad keytail not connected.F1-E2UL A/D error(s).F1-E5CANCEL key drive line open.F1-E6CANCEL key drive line open.F1E0EEPROM communications failure.F1E1EEPROM checksum failure.F1E3Fuel type (gas/electric) select failure.F2Touch panel failure.F2 E0Shorted key / Stuck key.F2 E1Keytail unplugged from control board.F2 EOShorted key on keypad.F2-E0Temperature sensor opened (R=2875 ohm by spec).F2-E1Temperature sensor shorted (R=825 ohm by spec).F2-E2Oven temp too highF2-E3Oven temp too high
View all 57 error codes
F2E0Key held down too long or shorted key.F2E1Keytail unplugged or damaged.F2E6CANCEL key failure.F3 E0Oven temperature sensor circuit is open.F3 E1Oven temperature sensor is shorted.F3 E2Bake range over temperature condition.F3 E3Clean range over temperature condition.F3-E0Door is open but latch is locked (door switch open indicating open door, latch…F3-E1Self-clean latch will not lock/unlock.F3-E2Oven temp too highF3-E3Oven temp too highF3E0Oven sensor opened.F3E1Oven sensor shorted.F3E2BAKE/BROIL range over temperature.F3E3CLEAN range over temperature.F5Door latch or lock system fault.F5 E0Door switch and latch switch do not agree.F5 E1Door lock solenoid not operating or latch switch failure.F5 E2Latch during CLEAN error.F5-E0Door is open but latch is locked (door switch is open indicating open door, and…F5-E1Self-clean latch will not lock/unlock.F5-E2Latch during CLEAN error.F5E0Door switches do not agree.F5E1Door latch not operating.F5E2Latch error during clean.F6MW relay (Relay 4903) failure.PFPower failure has occurred.

Service modes (22)

  • 12 hour shut-offPress and hold TIMER OFF key for 5 seconds.
  • Audible signal pitch controlPress and hold DELAY START key for 5 seconds.
  • Bake Temperature Offset AdjustmentPress BAKE pad for 5 seconds
  • Cavity Size ProgrammingWithin 60 seconds of power up, press the following touchpads in sequence
  • Cooktop lockoutPress and hold the TOP/TOP LIGHT keypad on the control panel for 5 seconds
  • Disable/Enable all tones (except end-of-timer and error tones)Press and hold COOK TIME key for 5 seconds.
  • Disable/Enable cycle and timer-end repeating tonesPress and hold TIMER SET key for 5 seconds.
  • Fahrenheit to Celsius conversionPress and hold BROIL key for 5 seconds.
  • Fault Code CheckPress and hold CANCEL key for 5 seconds.
  • Fault Code DisplayPress and hold CANCEL key for 5 seconds
  • Last error code recallPress and hold CANCEL/OFF key for 5 seconds until last error code is displayed.
  • Oven Temperature CalibrationPress and hold the BAKE keypad for 5 seconds. The current offset will be shown in the 3-digit…
  • Recall last failure codePress and hold the CANCEL/OFF key for 5 seconds
  • Sales demonstration modePress and hold START/ENTER key for 5 seconds.
  • Self-Diagnostic / Touch Panel and PCBA Test["Press and hold the STOP/CLEAR button while opening the door.","While still holding the STOP/CLEAR…
  • Software revision numberPress and hold TIME key for 5 seconds.
  • Temperature Adjustment (Calibration)Press and hold BAKE pad for 5 seconds
  • Temperature Calibration AdjustmentPress and hold BAKE pad for 5 seconds. Current offset (if any) is shown in 3-digit display. CAL is…
  • Temperature calibration offsetPress and hold BAKE pad for 5 seconds
  • Test mode (diagnostic)Within 60 seconds of power up, simultaneously hold down the BAKE and CLOCK keys for 5 seconds
  • Test mode readoutAfter entering test mode, press the arrow down key to cycle through
  • Verify fuel typePress and hold START/ENTER key for 5 seconds

Full entry steps, exit procedures, and test sequences are available in Max.

Related Magic Chef cooktop models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax