mypros+
Model reference

Magic Chef 22RW-4K-49

Range

2 documents22 error codes10 service modes

Available documentation

Tech Tip

  • product-inserts-W10623837-RevD.pdf4 pg
    Covers this model
  • product-inserts-W10622435-RevD.pdf2 pg
    Covers this model
MyPros+ Max

Diagnose your Magic Chef 22RW-4K-49.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (22)

CodeMeaning
F0E0No fault codes stored in memory.F0E2Over suds condition detectedF0E4High water temperature during rinse cycleF0E5Off balance load detected.F1E1Main control fault.F1E2Motor control faultF2E1Stuck keyF2E3Mismatch of main control and UIF3E1Pressure sensor faultF3E2Inlet water temperature faultF5E1Lid switch faultF5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF7E1Basket speed sensor faultF7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPMF8E1No fill, long fillF8E3Overflow conditionF8E5Hot and cold inlet hoses are reversed.F9E1Long drain

Service modes (10)

  • Automatic Test Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until Spin LED is On and…
  • Calibration Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until Rinse LED is On and…
  • Fault Code Display Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until Done LED is On and…
  • Manual Test Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until Spin and Done LEDs are…
  • Programming Mode (Electronic Models)1
  • Service Diagnostic Test Modes (Entry)["Ensure washer is in standby mode (plugged in with all indicators off).","RESET
  • Software Version Display Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until Rinse, Spin, and Done…
  • Tachometer Verification Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until Wash and Done LEDs are…
  • UI Test Mode["Activate Service Diagnostic Test Modes.","Turn cycle selector knob until Rinse and Spin LEDs are…
  • User Options Mode (Electronic Models)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Magic Chef range models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax