mypros+
Model reference

Magic Chef 38FA-2CX-OC

Range

1 document18 error codes6 service modes

Available documentation

Tech Sheet

  • TECH SHEET - W10159200 - Rev A6 pg
    Covers this model
MyPros+ Max

Diagnose your Magic Chef 38FA-2CX-OC.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (18)

CodeMeaning
DoorDoor Interlock Primary Switch issue.E0-F1EEPROM communications failure, typically caused by power line noise or…E0-F2EEPROM checksum failure, typically caused by power line noise or lightning.E0-F3Key contact closed for more than 60 secondsE0-F5Clean temperature out of range (too high)E1-F1EEPROM communications failure, typically caused by power line noise or…E1-F2EEPROM checksum failure, typically caused by power line noise or lightning.E1-F3Break in oven sensor circuit (open sensor, loosened or disconnected sensor…E1-F5Door switch open during clean cycleE2-F3Short in oven sensor circuit (short in sensor, sensor shorted to casing…E3-F3BAKE/BROIL temperature out of range (too high)Err1Failed H.VErr2Failed H.VErr3Failed H.VErr4Failed H.VErr5Shorted Touch Panel.Err6Failed H.VHOTThermal cutout has tripped due to overheating conditions (open magnetron TCO…

Service modes (6)

  • Forced Defrost Mode["1
  • Manual Diagnostics Mode 1 (Full - within 120 seconds of power up)Within 120 seconds of power-up, press Cancel/OFF, Cancel/OFF, then Start
  • Manual Diagnostics Mode 2 (Limited - after 120 seconds of power up)After 120 seconds of power-up, press Cancel/OFF, Cancel/OFF, then Start
  • Programming Mode["1
  • Service Test Mode["Unit must be in OFF condition or INITIAL power up mode.","Close oven door.","Press the Hidden Pad…
  • Temperature Adjustment (Calibration)Press and hold BAKE pad for 5 seconds

Full entry steps, exit procedures, and test sequences are available in Max.

Related Magic Chef range models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass