Model reference

Magic Chef U22FY-2LXY-6D

Range

7 documents17 error codes8 service modes

Available documentation

Service Manual

Service Manual - 1602183277 pg
Covers this model

Tech Sheet

Wiring Diagram - W10668584 - Rev A8 pg
Covers this model
Tech Sheet - W11087920 - Rev A60 pg
Covers this model
Tech Sheet - W10403269 - Rev A52 pg
Covers this model

Installation Guide

Installation Instructions12 pg
Covers this model
Installation Instructions12 pg
Covers this model
Installation Instructions16 pg
Covers this model

MyPros+ Max

Diagnose your Magic Chef U22FY-2LXY-6D.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Magic Chef Range

F1E1 on my Magic Chef U22FY-2LXY-6D

M+

Indicates a Cycle Control Unit (CCU)

From Service Manual 877977, p.29:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (17)

CodeMeaning

F1E1Indicates a Cycle Control Unit (CCU) problem.F2E1Indicates a stuck button (depressed for over 20 seconds) or UI mismatch; only…F2E2User Interface software error F3E1Exhaust thermistor is open; temperature drops below 18°F (>50k ohms).F3E2Exhaust thermistor has shorted; temperature above 250°F (<500 ohms).F3E3Inlet thermistor is open; temperature drops below 18°F (>245k ohms).F3E4Inlet thermistor is shorted; temperature above 391°F (<20 ohms).F3E5Inlet and exhaust thermistors are open; will occur if P14 connector is not…F3E6Moisture sensor strip is open; only appears in service diagnostic mode.F3E7Moisture sensor strip has shorted; only appears in service diagnostic mode.F4E1No voltage detected at the heater relay; only appears in service diagnostic…F4E3Restricted/low air flow that may affect dryer performance.F4E4Low L2 voltage (less than 50V) detected at installation.F6E1Communication error from UI to CCU; communication between CCU and UI has not…F6E2Communication error from CCU to UI; communication between CCU and UI has not…L2Low L2 voltage (less than 50V) detected at installation.PFPower failure occurred while the dryer was running.

Service modes (8)

Customer-Focused Dryness Level Adjustment1
Electronic Oven Control Test["1. Unplug the oven.","2. Remove the cabinet.","3. Discharge the HV capacitor with a 20,000 ohm…
Install Diagnostics1
Loads Test Mode["Ensure dryer is in standby mode (plugged in with all indicators off).","Within 5 seconds
Service Diagnostic Mode1. Ensure dryer is in standby mode (plugged in with all indicators off). 2. Select any three…
Software Version Display1
User Interface Test1
User Interface/Control System Test1. Activate Service Diagnostic Mode. 2. Press and release the 1st button used to activate Service…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Magic Chef range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass