Model reference

Maytag MED9000YR0

Dryer

5 documents18 error codes4 service modes

Available documentation

Tech Sheet

Tech Sheet - W1031551256 pg
Covers this model

Tech Tip

doorreversalkit-w10315279-revc.pdf8 pg
Covers this model
Instruction Sheet4 pg
Covers this model

Installation Guide

Inlet Hose Installation Instructions3 pg
Covers this model
Instruction Sheet8 pg
Covers this model

MyPros+ Max

Diagnose your Maytag MED9000YR0.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Maytag Dryer

AF on my Maytag MED9000YR0

M+

Restricted/low air flow detected that

From Tech Sheet W14143457, p.29:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (18)

CodeMeaning

AFRestricted/low air flow detected that may affect dryer performance.F1E1Indicates a CCU (Cycle Control Unit) problem.F2E1Stuck button (depressed for over 20 seconds) or UI mismatch; only appears in…F2E2UI software error; UI cannot read EEPROM software.F3E1Exhaust thermistor is open; temperature drops below 18°F (>50k ohms).F3E2Exhaust thermistor has shorted; temperature above 250°F (<500 ohms).F3E3Inlet thermistor is open; temperature drops below 18°F (>245k ohms)F3E4Inlet thermistor is shorted; temperature above 760°F (<20 ohms)F3E5Both inlet and exhaust thermistors are open; will occur if P14 connector is not…F3E6Moisture sensor strip is open F3E7Moisture sensor strip has shorted F4E1No voltage detected at the heater relay F4E3Restricted air flow detected that may affect dryer performance.F4E4Low L2 voltage (less than 30V) detected at the CCU.F6E1Communication error from UI to CCU; communication has not been detected.F6E2Communication error from CCU to UI; communication has not been detected.L2Low L2 voltage (less than 30V) detected at the CCU.PFPower failure occurred while the dryer was running.

Service modes (4)

Component ActivationFrom Service Diagnostics Diagnostics Home screen, select 'Component Activation'
Quick Diagnostic TestFrom Service Diagnostics, navigate to Error Diagnostic, then select 'Quick Diagnostic Test'
Service Diagnostics1. Ensure dryer is in standby mode (plugged in with all indicators off). 2. Select any three…
UI Component TestFrom Service Diagnostics, navigate to Component Activation, then select 'UI Component Test'

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass