Model reference

Maytag MGD8100DC0

Dryer

8 documents16 error codes6 service modes

Available documentation

Tech Sheet

TechSheet W10806850 RevA60 pg
Covers this model
Tech Sheet - W10606147 - Rev B60 pg
Covers this model

Tech Tip

Inlet Hose Connection Instructions4 pg
Covers this model

Quick Reference

Quick Reference Manual2 pg
Covers this model
Manual de referencia rapida1 pg
Covers this model

Installation Guide

Installation Instructions28 pg
Covers this model
Installation Instructions44 pg
Covers this model
Instrucciones de instalacion22 pg
Covers this model

MyPros+ Max

Diagnose your Maytag MGD8100DC0.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Maytag Dryer

F1E1 on my Maytag MGD8100DC0

M+

Indicates a CCU (Cycle Control Unit)

From Tech Sheet W12980263, p.35:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (16)

CodeMeaning

F1E1Indicates a CCU (Cycle Control Unit) problem.F2E1Indicates a stuck button (depressed for over 20 seconds) or UI mismatch; only…F3E1Exhaust thermistor is open; temperature drops below 18°F (>50k ohms).F3E2Exhaust thermistor has shorted; temperature above 250°F (<500 ohms).F3E3Inlet thermistor is open; temperature drops below 18°F (>245k ohms).F3E4Inlet thermistor is shorted; temperature above 391°F (<328 ohms).F3E5Inlet and exhaust thermistors are both open; will occur if P14 connector is not…F3E6Moisture sensor strip is open; only appears in service diagnostic mode.F3E7Moisture sensor strip has shorted; only appears in service diagnostic mode.F4E1No voltage detected at the heater relay; only appears in Diagnostic Test Mode.F4E3Restricted/low air flow detected that may affect dryer performance.F4E4Low L2 voltage (less than 50V) detected at the CCU.F6E1Communication error from UI to CCU; communication between CCU and UI has not…F6E2Communication error from CCU to UI; communication between CCU and UI has not…L2Low L2 voltage (less than 50V) detected at the CCU.PFPower failure occurred while the dryer was running.

Service modes (6)

Customer-Focused Dryness Level Adjustment1
Install Diagnostics1
Loads Test Mode1. Dryer must be in standby mode (plugged in with all indicators off). 2. Within 5 seconds: press…
Service Diagnostic Mode1. Dryer must be in standby mode (plugged in with all indicators off). 2. Select any three buttons…
Software Version Display1
User Interface Test["Activate Service Diagnostic Mode first.","Press and release the 1st button used to activate…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass