Model reference

Maytag W10156733A

Dryer

1 document25 error codes4 service modes

Available documentation

Tech Sheet

Tech Sheet W10156733A Maytag Dryer MEDB200VQ012 pg
Covers this model

MyPros+ Max

Diagnose your Maytag W10156733A.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Maytag Dryer

AF on my Maytag W10156733A

M+

Restricted air flow condition exists.

From Tech Sheet W18367153, p.45:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (25)

CodeMeaning

AFRestricted air flow condition exists.F:01Primary control failure.F:02Stuck button or user interface mismatch (appears ONLY in diagnostic test mode).F:20No voltage detected at the heater relay (appears ONLY in diagnostic test mode).F:22Exhaust thermistor is open.F:23Exhaust thermistor has shorted.F:24Inlet thermistor is open (appears ONLY in diagnostic test mode).F:25Inlet thermistor is shorted (appears ONLY in diagnostic test mode).F:26Motor drive system failure.F:28Moisture sensor strip is open (appears ONLY in diagnostic test mode).F:29Moisture sensor strip has shorted (appears ONLY in diagnostic test mode).F:30Restricted air flow condition exists (appears ONLY in diagnostic test mode).F:31Low voltage condition (less than 30V) detected (appears ONLY in diagnostic test…F:50No voltage detected at the water valve relay (appears ONLY in diagnostic test…F:70No communication between the machine control and the console electronics.F:71No communication between the machine control and the console electronics.F:72Console electronics failure (F:72 through F:78).F:73Console electronics failure (F:72 through F:78).F:74Console electronics failure (F:72 through F:78).F:75Console electronics failure (F:72 through F:78).F:76Console electronics failure (F:72 through F:78).F:77Console electronics failure (F:72 through F:78).F:78Console electronics failure (F:72 through F:78).L2Low or no line voltage detected (less than 50V) at installation.PFPower failure occurred while the dryer was running.

Service modes (4)

Customer-Focused Drying Mode Adjustment["In Standby mode (dryer plugged in but not powered up), press and hold the Dryness Level button…
Diagnostic Test Mode["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Dry…
Factory Default Reset["Select the Timed Dry cycle.","Press WRINKLE PREVENT, DAMP DRY SIGNAL, WRINKLE PREVENT, DAMP DRY…
Manual Load Test["Ensure dryer is in standby mode (plugged in with all indicators off, or with only the Dry…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass