mypros+
Model reference

Maytag YMED5430PBK0

Dryer

3 documents25 error codes10 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W11495041 - Rev D2 pg
    Covers this model

Service Manual

  • TECHNICAL MANUAL - Maytag® Dryer W11565060A144 pg
    Covers this model

Quick Reference

  • Quick Start Guide2 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag YMED5430PBK0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (25)

CodeMeaning
F0E2Oversuds condition detectedF0E3OverloadF0E4Spin limited by water temperatureF0E5Off balance load detected.F0E7Load detected when running Clean Washer cycle.F0E8Water ringF0E9Off balance pauseF1E1Motor circuit is open or shorted, OR heat system is open or shorted (heat…F2E1Stuck HMI button (depressed for over 20 seconds).F2E2HMI disconnected from the ACU.F3E1Exhaust thermistor is open or shorted; open if temperature drops below 18°F…F3E2Moisture sensor strip is open or shorted; this fault code only appears when in…F5E1Lid switch faultF5E3Lid lock will not unlockF5E4Lid not opened between cyclesF6E1Communication errorF7E1Tachometer missing or wrong signalF7E3Basket engaged during washF7E4Basket re-engagement failureF7E6Motor circuit openF7E7Motor unable to reach target RPM.F8E1Long fillF8E3Overflow or flood conditionF8E6Water hazardF9E1Drain pump system problem

Service modes (10)

  • Automatic TestFrom Service Diagnostic Mode
  • Automatic Test Mode["Enter Service Diagnostic Mode first.","Rotate encoder 3 until LED2 is ON.","Press SW2/Start key…
  • Factory Calibration Cycle["Ensure washer is in standby mode (plugged in with all LEDs off) and lid is closed.","Within 8…
  • Fault HistoryFrom Service Diagnostic Mode
  • Fault History Display["Enter Service Diagnostic Mode first.","Rotate encoder 3 until LED1 is ON.","Press SW2/Start…
  • HMI TestFrom Service Diagnostic Mode
  • Service Diagnostic Mode1. Ensure dryer is in standby mode (plugged in with all LEDs off). 2. Within six seconds, using the…
  • Software Version["Enter Service Diagnostic Mode.","Rotate E3 clockwise until LED4 is ON.","Press START key."]
  • Software Version DisplayFrom Service Diagnostic Mode
  • UI Test["Enter Service Diagnostic Mode.","Rotate E3 clockwise until LED3 is ON.","Press START key."]

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass