Model reference

Maytag YMED7000XW3

Dryer

5 documents19 error codes5 service modes

Available documentation

Tech Sheet

Tech Sheet - W10420007 - Rev A56 pg
Covers this model

Service Flash

Steam Dryer Hose Kit6 pg
Covers this model

Tech Tip

Instruction Sheet4 pg
Covers this model
Instruction Sheet - W10318609- Rev A - Special Handling7 pg
Covers this model

Installation Guide

Instrucciones de instalacion19 pg
Covers this model

MyPros+ Max

Diagnose your Maytag YMED7000XW3.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Maytag Dryer

AF on my Maytag YMED7000XW3

M+

Restricted air flow detected that may

From Tech Sheet W12233635, p.47:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (19)

CodeMeaning

AFRestricted air flow detected that may affect dryer performance.F1E1Indicates a CCU (Cycle Control Unit) problem.F2E1Indicates a stuck button (depressed for over 20 seconds) or UI mismatch F2E2UI cannot read EEPROM software from UI.F2E3Main control EEPROM is not programmed correctly.F3E1Exhaust thermistor is open F3E2Exhaust thermistor has shorted F3E3Inlet thermistor is open F3E4Inlet thermistor is shorted F3E5Inlet and exhaust thermistors are both open F3E6Moisture sensor strip is open F3E7Moisture sensor strip has shorted F4E1No voltage detected at the heater relay F4E3Restricted air flow that may affect dryer performance.F4E4Low L2 voltage (less than 50V) detected at the CCU.F6E1Communication between CCU and UI has not been detected (UI to CCU communication…F6E2Communication between CCU and UI has not been detected (CCU to UI communication…L2Low L2 voltage (less than 50V) detected at the CCU.PFPower failure occurred while the dryer was running.

Service modes (5)

Customer-Focused Dryness Level Adjustment1
Install Diagnostics1
Service Diagnostic Mode1. Ensure dryer is in standby mode (plugged in with all indicators off). 2. Select any three…
Software Version Display1
User Interface/Control System Test1. Activate Service Diagnostic Mode first. 2. Press and release the 1st button used to activate…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass