Model reference

Merloni ElectroméNager TIG664

Name: Merloni ElectroméNager TIG664
Brand: Merloni ElectroméNager

Cooktop

1 document29 error codes3 service modes

Available documentation

Service Manual

Induction - Main Principles29 pg
Covers this model

MyPros+ Max

Diagnose your Merloni ElectroméNager TIG664.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Merloni ElectroméNager Cooktop

88 on my Merloni ElectroméNager TIG664

M+

General error code displayed during

From Service Manual 353524, p.16:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (29)

CodeMeaning

88General error code displayed during normal operation when a fault is present…E.00Keyboard display error.E.12EEPROM (statistical memory) fault.E.20Key(s) out of action.E.21ON/OFF key out of action.E.22Keyboard temperature sensor in short circuit (CC).E.23Keyboard temperature sensor in open circuit (CO).E.24REL cooking zone temperature sensor in short circuit (CC).E.25REL cooking zone temperature sensor in open circuit (CO).E.26RER element temperature sensor in short circuit (CC).E.27RER cooking zone temperature in open circuit (CO).E.30FRL cooking zone temperature sensor in short circuit (CC).E.31FRL cooking zone temperature sensor in open circuit (CO).E.32FRR cooking zone temperature sensor in short circuit (CC).E.33FRR cooking zone temperature in open circuit (CO).E.34Dissipator temperature sensor of Supplying Generator in short circuit (CC).E.35Dissipator temperature sensor of Supplying Generator in open circuit (CO).E.40Dissipator temperature sensor of Communicating Generator in short circuit (CC).E.54Dissipator temperature sensor of Communicating Generator in open circuit (CO).E.55Synchro signal absent.E.60Communication fault / 12V DC voltage absent.E.70No communication with Supplying Generator.E.71No communication with Communicating Generator.E.72Communication delay with Supplying Generator.E.73Communication delay with Communicating Generator.E.74Communication interference (Checksum) between Supplying Generator and Keyboard.E.75Communication interference (Checksum) between Communicating Generator and…E.76Communication interference (Checksum) between Supplying Generator and Keyboard…E.77Communication interference (Checksum) between Communicating Generator and…

Service modes (3)

Diagnostic Display (TIG664)["Press and hold the Stop/Start button until '88' code appears.","While holding Stop/Start, press…
Infrared Remote Control Diagnostic (TIG664 only)["Press ON key on remote control to take control (3 beeps).","Press DIA key to start a diagnostic…
Remote Control Special Functions (FONC) - TIG664 only["Press ON key to take control (3 beeps).","Press CODE key (1 beep).","Enter code 0123 for level I…

Full entry steps, exit procedures, and test sequences are available in Max.

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass