mypros+
Model reference

Thermador SMW272YP

Oven

1 document5 error codes3 service modes

Available documentation

Service Manual

  • SMW Series Oven Training Program114 pg
    Covers this model
MyPros+ Max

Diagnose your Thermador SMW272YP.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (5)

CodeMeaning
F1Element supervisor enabled, indicating a fault on the main power/relay board.F1/F7F1 and F7 alternating indicates poor connection between display head and touch…F2Oven temperature detected or door light coming on after 1 hour into self-clean…F3Open oven sensor or open circuit wiring in the sensor circuit.F4Short in oven sensor circuit.

Service modes (3)

  • Electronic oven control test mode["Power up unit.","Within 5 minutes, before any other programming, hold the STOP TIME pad key for…
  • End of cycle chime restore["Touch Upper oven OFF pad for 10 seconds until you hear the chime."]
  • Oven Temperature Calibration["Touch BAKE pad.","Set temperature between 500 and 550.","Hold BAKE pad for 4 seconds.","0 or last…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Thermador oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass