mypros+
Model reference

Wascomat EX30C

Washer

1 document23 error codes2 service modes

Available documentation

Service Manual

  • OPERATING & MAINTENANCE MANUAL EX 30 C and EX 50 C Clarus Control161 pg
    Covers this model
MyPros+ Max

Diagnose your Wascomat EX30C.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (23)

CodeMeaning
01Water level has not reached set level within 10 minutes (NO WATER).02Door status switch open during wash (DOOR OPEN).03Acknowledgement signal from door lock switch absent at program start or during…04Temperature sensor indicating a temperature below lowest allowable value…05Temperature sensor indicating a temperature above highest allowable value…06The water level is higher than the EMPTY level at start of program (WATER IN…07The water level is above the set safety level during program operation or…08Rate of temperature increase in water slower than minimum value allowed…10The water level is higher than the EMPTY level after drain sequence (NOT…13Communication between PCU and motor control unit interrupted or disturbed (NO…14Level system not calibrated at factory (LEVEL CALIBRATION)15The emergency stop button has been pressed (EMERGENCY STOP).17No signal from door status switch although door is locked (DOOR LOCK).20MCU not receiving interlock signal during program operation (INTERLOCK STATUS).21Communication between CPU board and one of the I/O boards disturbed or lost, or…23Error message from equipment for monitoring mains power supply (PHASE).31Temperature of MCU heat sink too high (HEAT SINK TOO HOT).32Thermal protection for motor has cut out (MOTOR TOO HOT).33Motor control unit receiving start command from PCU without first receiving…35Motor control unit indicating short-circuit between outputs for motor windings…36Motor control unit indicates fault in receiving circuitry for lock…37Motor control unit indicating DC voltage level too low (LOW DC VOLTAGE).38Motor control unit indicating DC voltage level too high (HIGH DC VOLTAGE).

Service modes (2)

  • Manual Mode (no program running)["From main screen, press back key repeatedly to return to main menu.","Select 'GO TO THE MENU' and…
  • Service Program["From main screen, press back key repeatedly to return to main menu.","Select 'GO TO THE MENU' and…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Wascomat washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax