mypros+
Model reference

Wascomat FLE120FC

Washer

1 document13 error codes7 service modes

Available documentation

Service Manual

  • Operating & Maintenance Manual84 pg
    Covers this model
MyPros+ Max

Diagnose your Wascomat FLE120FC.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (13)

CodeMeaning
!!!EMERGENCY STOP USED!!!The emergency stop button has been activated.DOOR LOCK ERRORDoor lock is not locking correctly.HIGH TEMPERATUREWater temperature has exceeded safe limits.NO HEATHeating system is not functioning; may be caused by blown fuses or lack of…NO WATER. CHECK INLET!Water is not reaching the machine; manual shut-off valves may be closed or…OPEN CIRCUIT IN TEMPERATURE SENSORTemperature sensor circuit is open (broken or disconnected).PHASE OR DOOR LOCK ERRORPhase power or door lock wiring issue, typically seen during installation.SWITCH FOR UNBALANCE DETECTION IS ONThe imbalance detection switch is triggered or improperly fitted.TACHO ALWAYS INDICATING HIGH SPEEDSpeed sensor is indicating high speed when the machine is at low speed.TACHO ALWAYS INDICATING LOW SPEEDSpeed sensor is indicating low speed during extraction.THE DOOR IS OPENDoor is not properly closed or door switch is not detecting a closed door.WATER IN MACHINEWater is present in the machine drum at startup, indicating a possible blocked…WATER LEFTWater could not be drained within the programmed drain time, possibly due to…

Service modes (7)

  • Built-in service program (electronic timer)Contact service personnel for further information.
  • Program statisticsSelect program number 00 and press PROG
  • Programming modeTurn the key switch from RUN to the PROGRAM position.
  • Service program 91 - Flush TankSelect program number 91 from the control panel and press START.
  • Service program 92 - Empty TankSelect program number 92 from the control panel and press START.
  • Service program 93 - Test/Clean PumpSelect program number 93 from the control panel and press START.
  • Service program 94 - Clean Nozzle/Clean Spray PumpSelect program number 94 from the control panel and press START.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Wascomat washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax