Model reference
Wascomat W245SELECTA28
Washer
1 document16 error codes1 service mode
Available documentation
Service Manual
- OPERATING & MAINTENANCE MANUAL - WASCOMAT W 245 Selecta 2876 pg
MyPros+ Max
Diagnose your Wascomat W245SELECTA28.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax
Error codes (16)
CodeMeaning
01EWater level not reached within set time (acknowledgement signal for water level…02EDoor status switch open during program operation.03EThe lock has not locked the door within the set time.04EThe temperature sensor indicates temperature below -5°C (open circuit).05EThe temperature sensor indicates temperature above 98°C (short-circuit).06EThe water level is above the safety level set for starting.07EThe water level is above the safety level set for program operation.08ETemperature increase in water less than 5°C per 10 minutes (heated machines).10EThe water level is above the safety level set for after drain.12EThe program control unit cannot read the program EPROM.13EProgram control unit receiving no response from the motor control unit.14ELevel system not temperature-calibrated17EDoor status switch open even though the door lock is locked.20EInterlock signal absent at motor control unit during program operation.43EUnbalance switch on when motor not rotating.45ETacho error (speed sensor/tachometer fault).Service modes (1)
- Service program (diagnostic mode)["Remove the machine top panel and the cover for the program unit circuit board.","Press the…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Wascomat washer models
75,000+ service documents · 20,000+ error codes · 100+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax