mypros+
Model reference

Whirlpool And Maytag WGD9620HW0

Dryer

13 documents9 error codes12 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W1118490165 pg
    Covers this model
  • Tech Sheet - W11438132 - Rev A2 pg
    Covers this model
  • Tech Sheet W1118489968 pg
    Covers this model

Service Manual

  • Service Manual Whirlpool & Maytag 27" Front-load Gas & Electric Dryers80 pg
    Covers this model

Service Flash

  • Technical Service Pointer6 pg
    Covers this model
  • Technical Service Pointer15 pg
    Covers this model

Tech Tip

  • Door Reversal Guide8 pg
    Covers this model
  • Inlet Hose Connection Instructions4 pg
    Covers this model

Quick Reference

  • Manual de referencia rapida1 pg
    Covers this model
  • Quick Reference Sheet1 pg
    Covers this model
  • Quick Reference Sheet2 pg
    Covers this model

Other

  • service pointer w113770723 pg
    Covers this model

Installation Guide

  • Instrucciones de instalacion24 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool And Maytag WGD9620HW0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (9)

CodeMeaning
F1E1No voltage detected at the heater relay, indicating a motor or heater failure…F3E1Exhaust thermistor is open or shorted; open if temperature drops below 18°F…F3E2Moisture sensor strip is open or shorted (only appears in service diagnostic…F3E3Inlet thermistor is open or shorted; open if temperature drops below 18°F…F3E5Moisture Sensor 2 Open/Shorted (only Quad Sense models).F6E1Communication between the ACU and HMI has not been detected.F6E2Communication between the ACU and HMI has not been detected.FCE1WIFI Module has not responded for a specified amount of time.PFPower failure occurred while the dryer was running.

Service modes (12)

  • Component Activation / Quick Service Cycle (LCD in Door Models)["Enter Service Diagnostic Mode (LCD in Door) first.","From the DIAGNOSTICS HOME screen, scroll…
  • Fault Code Display and Clearing1
  • Fault/Error Code Display["From the DIAGNOSTICS HOME screen, press ERROR DIAGNOSTIC button."]
  • Key Activation & Encoder Test (Console Models)["Activate Service Diagnostic Mode first.","Press and release the 1st button used to activate…
  • Key Activation and Encoder Test1
  • Service Diagnostic Mode["1
  • Service Diagnostic Mode (Console Models)["Ensure the dryer is in standby mode (plugged in with all indicators off).","Select any three (3)…
  • Service Diagnostic Mode (LCD in Door Models)["Ensure the dryer is in standby mode (plugged in with all indicators off).","Open and close the…
  • Service Test Mode["Activate Service Diagnostic Mode first.","From the Diagnostics Home screen, scroll down and…
  • Service Test Mode (Console Models)["Activate Service Diagnostic Mode first.","Press and release the 2nd button used to activate…
  • Software Version Display["From DIAGNOSTICS HOME, navigate to System Info > Software Version."]
  • Software Version Display (Console Models)["Activate Service Diagnostic Mode first.","Press and hold the 2nd button used to activate Service…

Full entry steps, exit procedures, and test sequences are available in Max.

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass