mypros+
Model reference

Whirlpool SAC301-P1

Compactor

1 document39 error codes16 service modes

Available documentation

Installation Guide

  • Installation Instructions20 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool SAC301-P1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (39)

CodeMeaning
AFRestricted airflow detected that may affect dryer performance.d13The Coin 2 sensor is detected as blocked; coin vault may be full of money, or…d16Gen 2 Debit Card Reader Errord5The Coin 1 sensor is detected as blocked; coin vault may be full of money, or…d9Low voltageF01Indicates a main control fault.F03Main control detects an out of range pressure signal from the pressure…F07Main control cannot determine position of shifter (shifter system failure).F11Motor control faultF1E1Motor relay stuck on, indicates an ACU problem.F1E3Incorrect controller installed (electric models only); ACU and/or UI part…F20Long fillF21Long drainF22Lid lock faultF24Inlet water temperature faultF25Basket speed sensor faultF26Lid switch faultF27Overflow conditionF29Lid unlock faultF2E1User Interface stuck button (depressed for over 20 seconds); only appears in…F2E4UI Software ErrorF2E5UI Software ErrorF32No fillF3E1Exhaust thermistor is open or shortedF3E2Moisture sensor strip is open or shorted; only appears in service diagnostic…F3E3Inlet thermistor is open or shortedF4E1Heater 1 failure or connector problem; no voltage detected at the heater relay.F4E2Heater 2 failure or connector problem (electric models only); no voltage…F4E3Restricted airflow that may affect dryer performance.F4E4L2 line voltage error (less than 50 V detected at the ACU), electric models…
View all 39 error codes
F6E2Communication errorF6E3Communication errorF70Communication failure between CCU and UIF71Communication failure between CCU and UIF73The User Interface EEPROM identification does not match the expected value in…F74The User Interface EEPROM identification does not match the expected value in…F77Off balance load detected.L2Low L2 voltage (less than 30 V) detected at the CCU.PFPower failure occurred while the dryer was running.

Service modes (16)

  • Adjusting Customer-Focused Dryness LevelIn standby mode (dryer plugged in but not powered up), press and hold the DRYNESS button for…
  • Help Mode["1
  • Key Activation & Encoder TestFrom Service Diagnostic Mode, press and release the 1st button used to activate Service Diagnostic…
  • P-01 Clear Errors["Access Service Diagnostic Test Modes.","Press START after 'P-01' is displayed to clear an active…
  • P-02 Cycle Credit["Access Service Diagnostic Test Modes.","Press Normal key pad to step to 'P-02'.","Press START…
  • P-03 Service Diagnostic["Access Service Diagnostic Test Modes.","Press Normal key pad to step to 'P-03'.","Press START…
  • P-04 Manual Diagnostic["Access Service Diagnostic Test Modes.","Press Normal key pad to step to 'P-04'.","Press START…
  • P-05 Calibration Cycle["Access Service Diagnostic Test Modes.","Press Normal key pad to step to 'P-05'.","Press START…
  • P-07 UI Diagnostics["Access Service Diagnostic Test Modes.","Press Normal key pad to step to 'P-07'.","Press START…
  • P-09 Tachometer Verification["Access Service Diagnostic Test Modes.","Press Normal key pad to step to 'P-09'.","Press START…
  • P-12 Clean Washer Cycle["Access Service Diagnostic Test Modes.","Press Normal key pad to step to 'P-12'.","Press START…
  • Service Diagnostic Mode1
  • Service Diagnostic Test Modes (entry)["1
  • Service Test ModeFrom Service Diagnostic Mode, press and release the 2nd button used to activate Service Diagnostic…
  • Software Version DisplayFrom Service Diagnostic Mode, press and hold the 2nd button used to activate Service Diagnostic…
  • Technician Service Access Code (free vend models only)["This method is only available on washers set to free vend (6 00).","Press the LEFT UPPER, RIGHT…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool compactor models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass