mypros+
Model reference

Whirlpool WED8500DR4

Dryer

13 documents18 error codes6 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W11089260 - Rev A60 pg
    Covers this model
  • Tech Sheet W11349684 RevA57 pg
    Covers this model
  • tech sheet W10777449 RevA60 pg
    Covers this model
  • Voltage Measurement Safety Information and Service Diagnostic Mode Technical Sheet60 pg
    Covers this model

Service Manual

  • Service Technician's Guide - WED85 Control Panel Diagnostics60 pg
    Covers this model

Service Flash

  • Service Pointer - W10768083 (Door Squeak)3 pg
    Covers this model

Bulletin

  • Service Pointer - W10767487A (Door Squeak)3 pg
    Covers this model

Quick Reference

  • Quick Reference Manual2 pg
    Covers this model
  • Manual de referencia rapida1 pg
    Covers this model
  • Quick Start Guide2 pg
    Covers this model

Installation Guide

  • Instrucciones de instalacion27 pg
    Covers this model
  • Installation Instructions44 pg
    Covers this model
  • Installation Instructions44 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WED8500DR4.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (18)

CodeMeaning
AFRestricted/low airflow detected that may affect dryer performance.F1E1Motor relay stuck on, indicates an ACU problem.F1E3Incorrect controller installed (electric models only); ACU or UI part number…F1E5ACU parameter file missing; parameter memory invalid.F2E1Stuck button on User Interface (depressed for over 20 seconds); only appears in…F2E4UI software errorF2E5UI software errorF3E1Exhaust thermistor is open (>50k ohms, below 18°F) or shorted (<500 ohms, above…F3E2Moisture sensor strip is open or shorted; only appears in service diagnostic…F3E3Inlet thermistor is open (>245k ohms, below 18°F) or shorted (<328 ohms, above…F4E1Heater 1 failure or connector problem; no voltage detected at the heater relay.F4E2Heater 2 failure or connector problem (electric models only); no voltage…F4E3Restricted airflow detected that may affect dryer performance.F4E4Low L2 voltage (less than 50V) detected at the ACU (electric models only).F6E2Communication errorF6E3Communication errorL2Low L2 voltage (less than 30V) detected at the CCU.PFPower failure occurred while the dryer was running.

Service modes (6)

  • Customer-Focused Dryness Level Adjustment1
  • Fault Code Display / ClearFrom Service Diagnostic Mode, press and release the 3rd button to display the next saved error code
  • Key Activation & Encoder Test1
  • Service Diagnostic Mode1. Ensure dryer is in standby mode (plugged in with all indicators off). 2. Select any three…
  • Service Test Mode1. Activate Service Diagnostic Mode first. 2. Press and release the 2nd button used to activate…
  • Software Version Display1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass