mypros+
Model reference

Whirlpool WGD5100HC2

Dryer

5 documents8 error codes8 service modes

Available documentation

Service Manual

  • For Service Technician's Use Only136 pg
    Covers this model

Tech Sheet

  • Service Guide - Tech Sheet W1117522244 pg
    Covers this model

Service Flash

  • 27" Dryer Top Panel Design Change Control Bracket Eliminated9 pg
    Covers this model

Tech Tip

  • Instruction Sheet - W11581423 - Rev A - Gas Conversion Kit42 pg
    Covers this model

Quick Reference

  • Quick Reference Guide16 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WGD5100HC2.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (8)

CodeMeaning
F1E1No voltage detected at the heater relay or main control (ACU) problem.F2E1Stuck button on HMI detected (depressed for over 20 seconds).F2E2The HMI has detected an internal fault.F3E1Exhaust thermistor is open (>50k ohms below 18°F) or shorted (<500 ohms above…F3E2Moisture sensor strip is open or shorted.F3E3Inlet thermistor is open (>245k ohms below 18°F) or shorted (<328 ohms above…F3E5Rear moisture sensor strip is open or shortedF6E1Communication between the HMI and ACU has not been detected.

Service modes (8)

  • Button Activation & Encoder Test["Activate Service Diagnostic Mode first.","Press and release the 1st button used to activate…
  • Diagnostic Cycle (Factory)["Enter Service Mode.","Navigate to Factory Diagnostics.","Select Diagnostic Cycle.","Press the…
  • Diagnostic Cycle (Service)["Enter Service Mode.","Navigate to Service Diagnostics.","Select Diagnostic Cycle.","Press the…
  • Fault Code Display / Clear["Activate Service Diagnostic Mode first.","Press and release the 3rd button used to activate…
  • Service Diagnostic Mode["Ensure dryer is in standby mode (plugged in with all LEDs off).","Select any three (3) buttons…
  • Service Mode["Ensure dryer is in standby mode (plugged in with all indicators off).","Select any three (3)…
  • Service Test Mode["Activate Service Diagnostic Mode first.","Press and release the 2nd button used to activate…
  • Software Version Display["Activate Service Diagnostic Mode first.","Press and hold the 2nd button used to activate Service…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass