mypros+
Model reference

Whirlpool WGD6120HW1

Dryer

7 documents8 error codes8 service modes

Available documentation

Tech Sheet

  • Service Guide - Tech Sheet W1117522244 pg
    Covers this model

Service Manual

  • Technical Manual - Whirlpool® and Maytag® Dryer61 pg
    Covers this model

Service Flash

  • 27" Dryer Top Panel Design Change Control Bracket Eliminated9 pg
    Covers this model

Tech Tip

  • Instruction Sheet22 pg
    Covers this model

Quick Reference

  • Quick Reference Guide16 pg
    Covers this model

Installation Guide

  • Installation Instructions28 pg
    Covers this model

Other

  • Service Pointer - W11727795 - Rev A - Dryer Unresponsive3 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WGD6120HW1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (8)

CodeMeaning
F1E1No voltage detected at the heater relay or main control (ACU) problem.F2E1Indicates a stuck button (depressed for over 20 seconds)F2E2The HMI has detected an internal fault (HMI Disconnected).F3E1Exhaust thermistor is open or shortedF3E2Moisture sensor strip is open or shorted.F3E3Inlet thermistor is open or shortedF3E5Rear moisture sensor strip is open or shorted.F6E1Communication between the HMI and ACU has not been detected.

Service modes (8)

  • Diagnostic CycleEnter Service Mode, navigate to Service Diagnostics, then select Diagnostic Cycle
  • Diagnostic Cycle (Factory)["Enter Service Mode.","Navigate to Factory Diagnostics.","Select Diagnostic Cycle.","Press the…
  • Diagnostic Cycle (Service Diagnostics)["Enter Service Mode.","Navigate to Service Diagnostics.","Navigate to Diagnostic Cycle and select…
  • Diagnostic Cycle (Service)["Enter Service Mode.","Navigate to Service Diagnostics.","Select Diagnostic Cycle.","Press the…
  • Factory Reset["Enter Service Mode.","Navigate to Factory Diagnostics.","Select Factory Reset."]
  • HMI Test["Enter Service Mode.","Navigate to Service Diagnostics.","Navigate to HMI Test and select…
  • Sensor Feedback["Enter Service Mode.","Navigate to Service Diagnostics.","Navigate to Sensor Feedback and select…
  • Service Mode["Ensure dryer is in standby mode (plugged in with all indicators off).","Select any three (3)…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass