mypros+
Model reference

Whirlpool YWED5100HC1

Dryer

3 documents8 error codes3 service modes

Available documentation

Service Manual

  • EnerGuide1 pg
    Covers this model

Tech Sheet

  • Service Guide - Tech Sheet W1117522244 pg
    Covers this model

Installation Guide

  • Installation Instructions88 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool YWED5100HC1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (8)

CodeMeaning
F1E1No voltage detected at the heater relay or main control (ACU) problem.F2E1Stuck button on HMI detected (depressed for over 20 seconds).F2E2The HMI has detected an internal fault.F3E1Exhaust thermistor is open (>50k ohms below 18°F) or shorted (<500 ohms above…F3E2Moisture sensor strip is open or shorted.F3E3Inlet thermistor is open (>245k ohms below 18°F) or shorted (<328 ohms above…F3E5Rear moisture sensor strip is open or shortedF6E1Communication between the HMI and ACU has not been detected.

Service modes (3)

  • Diagnostic Cycle (Factory)["Enter Service Mode.","Navigate to Factory Diagnostics.","Select Diagnostic Cycle.","Press the…
  • Diagnostic Cycle (Service)["Enter Service Mode.","Navigate to Service Diagnostics.","Select Diagnostic Cycle.","Press the…
  • Service Mode["Ensure dryer is in standby mode (plugged in with all indicators off).","Select any three (3)…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dryer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass