mypros+
Model reference

Whirlpool W10153974

Microwave

1 document14 error codes4 service modes

Available documentation

Tech Sheet

  • Fiche Technique - Ne Pas Jeter16 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W10153974.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (14)

CodeMeaning
F0E0No fault detected (GOOD)F3E1Lower oven sensor shorted or open.F3E3Meat probe shorted.F4E1Convection thermistor fault (microwave oven sensors).F4E2Internal temperature sensor fault (microwave oven sensors).F4E4Humidity sensor fault (microwave oven sensors).F5E0Door and latch switch do not agree.F5E1Door latch not operating.F6E0Lost communications between user interface and appliance manager.F6E3Mini oven/warm drawer over temperature (function not present on this oven).F6E4User interface / appliance manager mismatch.F6E5No cavity size command programmed.F7E0Water level is not high enough or water did not boil fast enough.F7E4Conductivity sensor not connected.

Service modes (4)

  • Cavity Size / Model ID Programming (after UI replacement)["Disconnect power","Replace user interface","Reassemble parts and panels","Reconnect power","MODEL…
  • Diagnostic Mode["Press OFF","Press OFF","Press START"]
  • Error Code Review Mode["Enter diagnostic mode (OFF, OFF, START)","Press ERROR CODES on the display"]
  • Extended Diagnostic Mode - Relay Activation["Enter diagnostic mode (OFF, OFF, START)","Select 30 for cavity size (press 30)","Access…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool microwave models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass