Model reference

Whirlpool YGSC308PJB0

Oven

5 documents24 error codes4 service modes

Available documentation

Tech Tip

Instruction Sheet1 pg
Covers this model

Quick Reference

Quick Reference Manual6 pg
Covers this model
Quick Reference Manual6 pg
Covers this model

Installation Guide

Installation Instructions10 pg
Covers this model
Installation Instructions20 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool YGSC308PJB0.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Oven

All Other Codes on my Whirlpool YGSC308PJB0

M+

Electronic control malfunction.

From Tech Sheet W15333401, p.13:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (24)

CodeMeaning

All Other CodesElectronic control malfunction.F0-E0Default F code F1-E0Door switch malfunction.F1-E1Door switch malfunction.F1-E2Door switch malfunction.F1-E3Electronic control malfunction.F1-E4Electronic control malfunction.F1-E5Electronic control malfunction (E5).F2-E0Key held down too long, or key is shorted.F2-E1Keypad not connected.F3-E0Temperature sensor opened.F3-E1Temperature sensor shorted.F3-E2Temperature sensor (microwave) opened.F3-E3Key held down too long, or key is shorted.F5-E0Lower cavity over temperature while cleaning.F5-E1Microwave cavity over temperature during cooking.F6-E0Lower cavity over temperature during cooking.F6-E1Microwave cavity over temperature during cooking.F8-E0Self-clean latch will not lock.F8-E1Self-clean latch will not unlock.F8-E2Oven over temperature while door open and latch lock.F8-E3Oven over temperature while door open and latch unlock.F8-E4Oven over temperature while door close and latch unlock.SABOven is in Sabbath Mode.

Service modes (4)

Bake Temperature Offset Adjustment1
Default Fault Code DisplayPress and hold CANCEL key for 5 seconds
Fahrenheit to Celsius Conversion1
Sabbath Mode ExitIf 'SAB' appears in digital display, press and hold the '6' key for 5 seconds to end Sabbath Mode.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass