mypros+
Model reference

Whirlpool MFW7020RF0

Refrigerator

3 documents26 error codes6 service modes

Available documentation

Bulletin

  • Service Pointer - W11819607 - Replacing both Appliance Control Unit (ACU) and Human Machine Interface (HMI) - Rev a17 pg
    Covers this model

Quick Reference

  • Quick Start Guide2 pg
    Covers this model

Other

  • W11678280 - Rev B3 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool MFW7020RF0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (26)

CodeMeaning
F0E1Load detected inside the drum during the Clean Washer cycle.F0E2Oversuds condition detected by the pressure sensor; ACU will flush water to…F0E3Overload condition indicating the washer is too full.F0E4Spin speed limited by water temperature.F0E5Off balance load condition detected during operation.F1E1Appliance Control Unit (ACU) fault.F1E2Fault of the motor control section of the ACU.F4E2Main wash heater is stuck on (heater relay closed).F4E3Main wash heater is not turning on (heater relay open).F5E1Door switch is open while the door is locked for more than 5 seconds.F5E2Door lock will not lock or door lock failure; ACU detects open door switch when…F5E3Door unlock failure; washer is unable to unlock the door or ACU cannot…F5E4Door not opened between cycles; user presses START after consecutive cycles…F6E1Communication errorF6E2Communication errorF6E3No communication between ACU and DMS.F7E2Motor control internal fault; ACU has detected a problem with the motor.F7E8Motor control over-temperature detected.F7E9Motor locked rotor condition.F7EAMotor control lost phase fault.F7ECMotor control motor overload fault.F8E1No fill, long fill, or water taps closed; water level does not change for a…F8E3Overflow condition detected.F8E5Hot and cold water supply hoses are reversed.F9E1Long drain; water level sensor does not change after the drain pump is on.FAE1Shipping bolts are still installed.

Service modes (6)

  • Component Activation["Enter Service Diagnostic Mode.","Navigate to Service Diagnostic.","Select Component…
  • Diagnostics Cycle["Enter Service Diagnostic Mode.","Navigate to Service Diagnostic.","Select Diagnostics…
  • Factory Calibration Cycle["Enter Service Diagnostic Mode.","Navigate to Factory Diagnostics.","Select Factory Calibration…
  • Factory Reset["Enter Service Diagnostic Mode.","Navigate to Factory Diagnostics.","Select Factory Reset."]
  • HMI Test["Enter Service Diagnostic Mode.","Navigate to Service Diagnostic.","Select HMI Test.","Sub-tests
  • Service Diagnostic Mode["Ensure washer is in standby mode (plugged in with all indicators off).","Wait 30 seconds after…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool refrigerator models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass