Amana Dryer Error Code E

The E code on an Amana dryer means an invalid selection was made on the electronic control display. The control board detected that the option or combination of options chosen is not compatible with the selected cycle. You can clear this by changing your selections to a valid combination for the cycle you want to run. Refer to the display section of your cycle guide to see which options are permitted for each cycle.

A power reset, done by unplugging the dryer for one to two minutes, may temporarily clear the E code. However, if you make the same invalid selection again, the code will return immediately. The lasting fix is to select a valid combination of cycle and options rather than relying on a reset alone.

If the issue is only an incompatible selection, there is no repair cost involved since adjusting the cycle options resolves it at no charge. If a faulty touchpad or control panel membrane is causing phantom inputs, replacement parts typically range from $30 to $100 depending on the model. A full control board replacement, if required, generally costs between $100 and $250 for parts, plus any applicable labor fees.

Start by identifying which option is incompatible with your selected cycle, using the display or cycle guide to check valid selections for that program. Change the conflicting option to one that is permitted and attempt to restart the cycle. If the code persists without any apparent invalid input, inspect the control panel buttons for physical sticking or damage. A faulty touchpad or control board may require replacement if no user input issue is found.

The E code is not a safety-related fault. It is a control logic notification indicating an incompatible user selection, not a sign of a mechanical or electrical hazard. The dryer will simply decline to run the invalid combination rather than proceeding unsafely. You can safely continue troubleshooting and adjusting your settings.