Bosch Dishwasher Error Code 1010

Error code 1010 on a Bosch dishwasher indicates an inverter error caused by a motor operation mismatch. The inverter board, which controls the wash motor's speed and torque, has detected that the motor's actual behavior does not match its expected parameters. The dishwasher shuts down to prevent further damage when this condition is detected.

No, you should not continue running the dishwasher while this error is active. The appliance will typically stop operation automatically when the fault is triggered, and attempting to force it through a cycle could worsen damage to the motor or inverter board. Leave the unit powered off until the root cause has been identified and corrected.

Repair costs vary depending on which component has failed. Harness repairs or connector replacements are typically on the lower end, often in the range of $75 to $200 including labor. A wash motor replacement generally falls between $150 and $350. Inverter board replacement tends to be the most expensive repair, commonly ranging from $200 to $450 depending on parts and labor rates in your area.

Some causes of this error, such as a loose connector at the inverter or motor, can be addressed by a knowledgeable DIYer comfortable working with appliance wiring. However, diagnosing whether the fault lies in the harness, the wash motor, or the inverter board requires electrical testing tools and familiarity with appliance electronics. If you are not confident working near live components, a qualified technician is the safer choice.

A reset may temporarily clear the error code from the display, but it will return as soon as the dishwasher attempts to run the motor again if the underlying fault has not been repaired. Resetting is useful for confirming whether the error is persistent or intermittent, but it is not a fix. The wiring, motor, and inverter board must be inspected to resolve the issue.