Bosch Dishwasher Error Code d:10

Error code d:10 means the dishwasher's power limiter circuit has shut off the motor due to an overload or binding condition. The control system detected that the wash motor was drawing excessive current, and cut power to protect the motor from damage. This is a protective fault, not a communication or sensor error. The underlying mechanical or electrical cause must be addressed before the unit will run normally again.

No, you should not continue running the dishwasher while d:10 is active. The power limiter shut down the motor specifically to prevent overheating and potential damage to the motor windings and control board. Repeatedly forcing the unit to run through the fault could result in permanent motor failure or, in a worst case, heat-related damage to nearby wiring. Address the cause of the binding before resuming normal use.

If the cause is simply a foreign object in the pump, the repair may cost nothing beyond your time, or a modest service call fee if a technician performs it. If the pump impeller is damaged, parts and labor can range from roughly $80 to $200 depending on your region and the specific model. A full motor replacement typically falls in the range of $150 to $350 or more, including parts and labor. Getting a diagnostic visit before committing to a repair is advisable to confirm the exact cause.

Start by running diagnostic test P:04 to observe motor behavior under controlled conditions. Before that, manually check the pump area at the bottom of the tub for any foreign objects like glass or debris that could be jamming the impeller. If no obstruction is found and the motor still trips the limiter during P:04, the motor itself may be worn or seized and will need replacement. Clearing the obstruction is a DIY-accessible fix, but motor replacement typically requires a technician.

A reset may temporarily clear the fault code and allow the dishwasher to attempt a cycle, but if the underlying cause of motor overload or binding has not been resolved, the d:10 error will return quickly. The power limiter will trigger again as soon as the motor encounters the same excessive load. A reset is only useful as a step after you have already corrected the mechanical problem, to confirm the repair was successful.